Page 1
Operating and installation instructions Cooker hood To prevent the risk of accidents or damage to the appliance, it is essential to read these instructions before it is installed and used for the first time. en-GB M.-Nr. 10 096 570...
Contents Warning and Safety instructions ................4 Caring for the environment ................. 13 Modes of operation....................14 Con@ctivity 2.0 function ..................15 Guide to the appliance..................16 Operation (Automatic mode)................18 Cooking with Con@ctivity 2.0 (Automatic mode)........... 18 Leaving automatic mode temporarily..............20 Returning to automatic mode ................
Page 3
Contents Safety distance between hob and cooker hood (S)..........35 Installation recommendations................36 Connection for air extraction ................37 Condensate trap ....................38 Silencer ........................38 Electrical connection ................... 40 Activating Con@ctivity 2.0................... 41 Installing the Con@ctivity 2.0 Stick................ 41 Activating Con@ctivity 2.0 ..................
They contain important notes on the safety, installation, use and maintenance of the appliance. Miele cannot be held liable for non-compliance with these instructions. Keep these instructions in a safe place and ensure that all users are familiar with the contents.
Unauthorised installation, maintenance and repairs can cause considerable danger for the user. Installation, maintenance and repairs must only be carried out by a Miele authorised technician. A damaged appliance can be dangerous. Check it for visible signs of damage. Do not use a damaged appliance.
Page 6
These models may only be combined with a Miele external motor. For safety reasons, this appliance may only be used after it has been built in.
Page 7
Warning and Safety instructions If the electrical connection cable is faulty it must only be replaced by a Miele authorised service technician to protect the user from danger. During installation, maintenance and repair work, the appliance must be disconnected from the mains electricity supply.
Page 8
Warning and Safety instructions Using at the same time as other heating appliances that depend on the air from the room Warning - danger of toxic fumes Great care should be taken when using the cooker hood at the same time and in the same room or area of the house as another heating appliance which depends on the air in the room.
Page 9
Warning and Safety instructions In order to ensure safe operation, and to prevent gases given off by the heating appliances from being drawn back into the room when the cooker hood and the heater are in operation simultaneously, an underpressure in the room of 0.04 mbar (4 pa) is the maximum permissible.
Warning and Safety instructions Correct use Never use a naked flame beneath the cooker hood. To avoid the danger of fire, do not flambé or grill over a naked flame. When switched on, the cooker hood could draw flames into the filter. Fat deposits could ignite, presenting a fire hazard.
Warning and Safety instructions Do not use the cooker hood without the filters in place. This way you will avoid the risk of grease and dirt getting into the appliance and hindering its smooth operation. There is a risk of fire if the cooker hood is not cleaned as described in these operating instructions.
Page 12
Warning and Safety instructions Exhaust ducting must be of non-inflammable material. Suitable material is available from Miele specialist dealers or the Miele Spares Dept. The appliance must not be connected to a chimney or flue which is in use. Neither should it be connected to ducting which ventilates rooms with fireplaces.
Caring for the environment Disposal of the packing Disposal of your old appliance material Electrical and electronic appliances often contain valuable materials. They The packaging is designed to protect also contain materials which, if handled the appliance from damage during or disposed of incorrectly, could be transportation.
Modes of operation Con@ctivity 2.0 function The hob transmits information about its operational status via a wireless signal Automatic control to the cooker hood. The cooker hood has a communication – When the hob is switched on, the facility which enables the automatic hob lighting comes on independently operation of the cooker hood and then after a short time the fan...
Page 17
Guide to the appliance a Drop-down vapour canopy b DADC 6000 tower Available as an optional accessory for concealing extraction ducting to the ceiling. c Charcoal filter Accessory required for recirculation mode d Hob lighting e Controls The symbols act as sensor controls. To select a function, touch the control. An audible tone sounds briefly to confirm selection.
Operation (Automatic mode) When Con@ctivity 2.0 is activated, the Reaction time cooker hood always works in automatic The cooker hood reacts with a slight mode (see "Activating Con@ctivity delay because altering the power level 2.0"). on the hob does not immediately result To operate the cooker hood manually, in a reduction or increase in cooking see "Cooking without Con@ctivity 2.0".
Operation (Automatic mode) Cooking process Switching off If for example you switch on a Switch off all cooking zones. cooking zone at the highest power The cooker hood fan will reduce its level to heat a pan for frying and power level over the next few minutes reduce the power level after approx.
Operation (Automatic mode) Leaving automatic mode Returning to automatic mode temporarily The cooker hood returns to automatic mode: To leave automatic mode temporarily during cooking: if the cooker hood has not been used for approx. 5 minutes after selecting ...
Operation (Manual mode) Cooking without Con@ctivity Selecting the run-on time 2.0 (Manual mode) It is advisable to run the fan for a few minutes after cooking has finished to The cooker hood can be operated neutralise any lingering vapours and manually if: odours in the air.
Operation (Manual mode) Power management Switching Power management on/off Switch off the fan and the lighting. The cooker hood features a power management system to help save Touch the run-on option control energy. The fan power level is reduced for approx.
Operation (Automatic and Manual modes) Operating hours counters The Grease filter symbol and one of the fan power level indicators will flash. The number of hours the appliance has Fan power level indicators 1 to IS show been in operation is stored in memory. the time set: When the Grease filter symbol ...
Operation (Automatic and Manual modes) Activating and altering the charcoal Reading the filter operating hours filter operating hours counter counter Charcoal filters are needed for To check the percentage of time set recirculation mode. already used The operating hours counter for the ...
Energy saving tips This cooker hood operates very – Make sure that you switch the efficiently and economically. The cooker hood off after use. following will help you to save even If cooking vapours and odours still more energy when using it: need to be removed from the kitchen air after cooking, use the –...
Please observe the following To help prevent re-soiling, a cleaning instructions. proprietary conditioning agent for stainless steel (available from Miele) All external surfaces and controls can can also be used. Follow the be cleaned using hot water with a manufacturer’s instructions on the...
Cleaning and care Grease filter Removing a grease filter The re-usable metal grease filter in the appliance removes solid particles from the kitchen vapours (grease, dust, etc) preventing soiling of the cooker hood. An oversaturated filter is a fire hazard.
Page 28
Cleaning and care Cleaning the grease filter by hand Cleaning the grease filter in a dishwasher Clean the filter with a soft nylon brush in a mild solution of hot water and a Place the filter as upright as possible in the lower basket, or at an angle, small amount of washing-up liquid.
This is designed to absorb cooking odours. It is fitted in the top of the cooker hood. Replacement charcoal filters can be obtained from Miele, your Miele dealer or via the internet at www.miele- shop.com. See "Technical data" for type and reference number.
Cleaning and care When to change the charcoal filter Always replace the charcoal filter when it no longer absorbs kitchen odours effectively. It should, however be replaced at least every 6 months. The charcoal filter operating hours symbol will light up to remind you to change the charcoal filter regularly.
Installation Before installation Before installation, it is important to read the information given on the following pages as well as the "Warning and Safety instructions" at the beginning of this booklet. Protective foil The housing components have protective foil around them to protect them from transport damage.
Page 33
Installation a 1 exhaust connection for exhaust ducting 150 mm b 1 reducing collar 5 screws 5 x 60 mm and for exhaust ducting 125 mm 5 plugs 8 x 50 mm 3 washers 6.4 mm c 1 non-return flap for securing to the wall.
Installation Appliance dimensions The diagram is not drawn to scale. a Extraction ducting to the rear, or alternatively upwards. b Cut-out for cooker hoods with hard-wired connection rather than a plug. c 200 mm cut-out ensures sufficient space through the wall for the extraction ducting to flex.
Installation d Ventilation outlet for recirculation mode. A gap of at least 300 mm must be maintained between the top of the cooker hood and the ceiling or any furniture above it. Connection for air extraction 150 mm, or 125 mm with reducing collar. Please observe installation positions for the socket and for the ducting outlet shown on the relevant drawings when using the DADC 6000 tower.
Installation Installation recommendations – Account should also be taken of the height of the person who will be using the hood most often. They should have sufficient space to work comfortably at the hob, and be able to reach the hood controls with ease. –...
Connection for air extraction – Ensure that all connections are If this cooker hood is used at the strong and airtight. same time as a heating appliance that relies on oxygen from the same Remember that any constriction of room there is a risk in certain the air flow will reduce extraction circumstances of toxic fumes...
Connection for air extraction Condensate trap Silencer To achieve even further reductions in noise levels, a special silencer (optional accessory) can be fitted in the ducting system. In addition to insulating the exhaust ducting, we recommend that a suitable Extraction mode condensate trap is also installed to collect and evaporate any condensate which may occur.
Page 39
Connection for air extraction Recirculation mode The silencer needs to be positioned between the exhaust socket and the directional unit . Ensure there is adequate space for fitting it. Extraction mode with external motor To minimise noise from the motor in the kitchen, the silencer should be positioned in front of the external motor ...
Electrical connection If the switch is not accessible after All electrical work should be installation (depending on country), an undertaken by a suitably qualified additional means of disconnection must and competent person in strict be provided for all poles. accordance with current national and For extra safety it is advisable to protect local safety regulations (BS 7671 in the appliance with a suitable residual...
Activating Con@ctivity 2.0 Installing the Con@ctivity 2.0 Activating the cooker hood Stick The hob and cooker hood must be switched off. In order to use the Con@ctivity 2.0 function, the hob must first be fitted Touch the run-on option control with the Con@ctivity 2.0 Stick.
Activating Con@ctivity 2.0 Activating the hob Activation failed While the cooker hood is searching If connection cannot be established for a signal, start activating the hob. despite activating the Con@ctivity More information about this can be function on the cooker hood and found in the Operating instructions hob, the function must be for the hob.
Miele dealer or the Miele Service Department. Contact details for Miele are given at the back of this manual. N.B. A call-out charge will be applied to service visits where the problem could have been resolved as described in these instructions.
Length of connection cable to external motor: 1.9 m Recirculation mode requires charcoal filter DKF 25-1 (available to order) Conformity declaration Miele hereby declares that the cooker hoods listed at the end of this booklet comply with the basic requirements and other relevant regulations of Guideline 1999/5/EC.
Data sheet for domestic cooker hoods In acc. with delegated regulation (EU) No. 65/2014 and regulation (EU) No. 66/2014 MIELE Model name / identifier DA 6796 W Annual Energy Consumption (AEC 34,1 kWh/year hood Energy efficiency class A+ (most efficient) to F (least efficient)
Data sheet for domestic cooker hoods In acc. with delegated regulation (EU) No. 65/2014 and regulation (EU) No. 66/2014 MIELE Model name / identifier DA 6796 W EXT Annual Energy Consumption (AEC 6,6 kWh/year hood Energy efficiency class A+ (most efficient) to F (least efficient)