Miele SmartLine Operating And Installation Instructions page 45
Induction cooktop
Hide thumbs
Also See for SmartLine:
- Operating and installation instructions (84 pages) ,
- Operating and installation instructions (80 pages)
Table of Contents
Advertisement
Problem
After the SmartLine
appliance has been
switched on or a sensor
control has been
touched, appears in
the timer display for a
few seconds.
The SmartLine
appliance has switched
off automatically. When
the appliance is
switched back on, an
appears above the On/
Off sensor control .
After the SmartLine
appliance has been
switched on, appears
briefly in the timer
display. The SmartLine
appliance does not heat
up.
A cooking zone
switches itself off
automatically.
A cooking zone or the
whole cooktop switches
off automatically.
The Booster has
automatically switched
off early.
The cooking zone is not
working in the usual
way on the power level
selected.
Possible cause and remedy
The system lock or safety lock is activated.
Deactivate the system lock or safety lock (see
"System lock / Safety lock").
One or more of the sensor controls are covered, e.g.
by finger contact, food boiling over or an object.
Clean off any dirt or remove the object (see
"Safety switch-off").
The SmartLine appliance is in demonstration mode.
Touch the 0 and 2 sensor controls at the same
time until flashes alternately with in the
timer display.
It has been operated for too long.
You can use the cooking zone again by switching
it back on (see "Safety features - Safety switch-
off").
The overheating protection mechanism has been
activated.
See "Overheating protection".
The overheating protection mechanism has been
activated.
See "Overheating protection".
The overheating protection mechanism has been
activated.
See "Overheating protection".
Problem solving guide
45
Advertisement
Table of Contents
