Table of Contents
Advertisement
Flush-fit installation
Create the worktop cut-out.
Remember to maintain the minimum
safety distances (see "Installation –
Safety distances").
Solid wood, tiled and glass worktops:
Fix a wooden frame 5.5 mm below
the top edge of the worktop (see the
diagram in "Installation – Installation
dimensions – Flush").
Feed the mains connection cable
down through the worktop cut-out.
Centre the cooktop in the cut-out.
The gap between the ceramic surface
and the worktop must be at least
2 mm wide. This is required so that the
cooktop can be sealed.
Connect the cooktop to the mains
electricity supply (see "Installation –
Electrical connection").
Check that the cooktop works.
Seal the gap between the cooktop
and worktop with a silicone sealant
that is heat-resistant to at least
160 °C.
Damage caused by unsuitable
sealant.
Unsuitable sealant can damage
natural stone.
For natural stone worktops and
natural stone tiles, only use silicone
sealant that is specially formulated
for natural stone. Please follow the
manufacturer's instructions.
Installation
89
Advertisement
Table of Contents
