Page 1
Operating and installation instructions Rangehood To prevent the risk of accidents or damage to the appliance, it is essential to read these instructions before it is installed and used for the first time. en-AU, NZ M.-Nr. 09 730 820...
It must only be used to extract vapours and remove odours from cooking. Any other usage is at the owner's risk. Miele cannot be held liable for damage resulting from incorrect or improper use or operation. This appliance is not intended for use by persons (including...
Page 5
Warning and Safety instructions Safety with children Young children must not be allowed to use this appliance. Older children may only use the appliance when its operation has been clearly explained to them and they are able to use it safely, recognising the dangers of misuse.
Repairs and other work by unqualified persons could be dangerous. Installation, maintenance work and repairs to electrical appliances must only be carried out by a Miele approved service technician. A damaged appliance can be dangerous. Check it for visible signs of damage.
Page 7
The manufacturer's warranty will be invalidated if the appliance is not repaired by a Miele approved service technician. Faulty components must only be replaced by genuine Miele spare parts. The manufacturer can only guarantee the safety of the appliance when Miele replacement parts are used.
Page 8
Warning and Safety instructions Using at the same time as other heating appliances that depend on the air from the room Warning - danger of toxic fumes Great care should be taken when using the rangehood at the same time and in the same room or area of the house as another heating appliance which depends on the air in the room.
Page 9
Warning and Safety instructions In order to ensure safe operation, and to prevent gases given off by the heating appliances from being drawn back into the room when the rangehood and the heater are in operation simultaneously, an underpressure in the room of 0.04 mbar (4 pa) is the maximum permissible.
Warning and Safety instructions Correct use Never use an open flame beneath the rangehood. To avoid the danger of fire, do not flambé or grill over an open flame. When switched on, the rangehood could draw flames into the filter. Fat deposits could ignite, presenting a fire hazard.
Warning and Safety instructions Do not use the rangehood without the filters in place. This way you will avoid the risk of grease and dirt getting into the appliance and hindering its smooth operation. The rangehood can get very hot during cooking due to heat rising from the cooktop.
Page 12
Accessories Use only genuine original Miele spare parts. If spare parts or accessories from other manufacturers are used, the warranty will be invalidated, and Miele cannot accept liability.
Caring for the environment Disposal of the packing Disposing of your old material appliance The transport and protective packing Electrical and electronic appliances has been selected from materials which often contain materials which, if are environmentally friendly for handled or disposed of incorrectly, disposal, and can normally be recycled.
Page 17
Guide to the appliance a Telescopic extension piece b Tower c Canopy d Touch controls e Grease filters f Recirculation grilles (only for recirculation mode) g Cooktop lighting h NoSmell active charcoal filter (special accessory for recirculation mode) i Touch control for switching the fan on and off j Touch control for cooktop lighting k Touch controls for selecting the fan power setting l Touch control for the run-on option...
Operation (automatic mode) If Con@ctivity 2.0 is activated, the Reaction time rangehood always operates in The rangehood reacts with a slight automatic mode (see "Activating delay because altering the power Con@ctivity 2.0"). setting on the cooktop does not To operate the rangehood manually, see immediately result in a reduction or "Cooking without Con@ctivity 2.0 increase in cooking vapours.
Operation (automatic mode) Cooking process Switching off If, for example, you switch on a Switch off all cooking zones. cooking zone at the highest power The rangehood fan will reduce its power setting to heat a pan for frying and level over the next few minutes and will reduce the power level after approx.
Operation (automatic mode) Leaving automatic mode Returning to automatic mode temporarily The rangehood returns to automatic mode: To leave automatic mode temporarily during cooking: if the rangehood has not been used for approx. 5 minutes after selecting a Manually select a different power power setting manually, or setting, or ...
Operation (manual mode) Cooking without Con@ctivity Selecting the run-on time 2.0 (manual mode) It is advisable to run the fan for a few minutes after cooking has finished to The rangehood can be operated neutralise any lingering vapours and manually if: odours in the air.
Operation (manual mode) Touch 1 to switch Power Switching the cooktop lighting management off. on/off The 1 and IS indicators will flash. The cooktop lighting can be switched on and off independently of the fan. Touch IS to switch it on. ...
Operation (automatic and manual modes) Fan power setting indicators 1 to IS Operating hours counter show the time set: The number of hours the appliance has 1..........20 hours been in operation is stored in memory. 2..........30 hours When the grease filter symbol or the charcoal filter symbol ...
Operation (automatic and manual modes) Activating and altering the operating Reading the filter operating hours hours counter for the NoSmell active counter charcoal filter To check the percentage of time set The charcoal filter is needed for already used: recirculation mode. ...
Operation (automatic and manual modes) Acoustic signal of the touch controls When selecting a function with the touch controls, an acoustic signal will sound for confirmation. The acoustic signal can be deactivated. Press the On/Off touch control to switch the fan off.
Energy saving tips This rangehood operates very efficiently – Make sure that you switch the and economically. The following will rangehood off after use. help you to save even more energy If cooking vapours and odours still when using it: need to be removed from the kitchen air after cooking, use the –...
The surfaces and controls are abrasive cleaning agent designed susceptible to scratches and specifically for use on stainless steel, abrasion. e.g. Original Miele ceramic and Please observe the following stainless steel cooktop cleaner. cleaning instructions. To help prevent re-soiling, a ...
Cleaning and care Grease filters The re-usable metal grease filters in the appliance remove solid particles (grease, dust, etc.) from the kitchen vapours, preventing soiling of the rangehood. An oversaturated filter is a fire hazard. When to clean the grease filters ...
Page 29
Cleaning and care If a grease filter is inadvertently Cleaning the grease filters in the dishwasher refitted upside down, insert a small screwdriver blade into the slit to Place the filters as upright as possible disengage the clip. in the lower basket, with the short sides upright, ensuring the spray arm Resetting the operating hours...
Unwrap the charcoal filter from its packaging. Replacement charcoal filters can be obtained from Miele. See back cover for contact details, and "Technical data" for type and reference number. Insert the charcoal filter into the back of the charcoal filter frame, then push up into the frame at the front.
Cleaning and care Resetting the operating hours counter for the charcoal filter After changing the charcoal filter, the operating hours counter needs to be reset. Touch the charcoal filter control for approx. 3 seconds with the rangehood switched on until only the indicator light for fan power setting 1 is flashing.
After sales service and warranty In the event of a fault which you cannot remedy yourself, please contact Miele. The contact details for Miele are given at the back of these instructions. When contacting Miele, please quote the model and serial number of your appliance.
Installation Before installation Dismantling Should the appliance ever need to be Before installation, it is important dismantled, follow the installation to read the information given on the instructions in reverse order as following pages as well as the described on the installation sheet. A "Warning and Safety instructions"...
Page 35
Installation a 3 protective sheets for use when fitting the tower. b 1 exhaust connection 6 screws 5 x 60 mm and for exhaust ducting 150 mm. 6 plugs 8 x 50 mm for securing the wall bracket. c 1 reducing collar for exhaust ducting 125 mm.
Installation a Extraction b Recirculation c Ventilation grille positioned at the top for recirculation de (only d is required for recirculation mode rangehoods): The shaded area represents the wall or ceiling area for the vent cut-out, for fitting the connection socket and on EXT models for feeding the connection cable through to the external motor.
Installation Installation recommendations Drilling diagram for wall mounting – When deciding on the safety distance between the cooktop and rangehood, Please follow the directions given in please note that a distance of 650 the installation instructions supplied mm above electric cooktops may be for drilling.
Connection for air extraction – A reduction in diameter will Before installation, it is important compromise the extraction to read the information given on the performance of the rangehood. following pages as well as the "Appliance dimensions" and the –...
Connection for air extraction When ducting is horizontal it must be exhaust socket. laid to slope away at at least 1 cm per The arrow on the housing indicates metre. This is to ensure that the direction of airflow. condensate cannot drain back into The condensate trap will be integrated the rangehood.
Page 41
Connection for air extraction Recirculation mode The silencer needs to be positioned between the exhaust connection and the directional unit . Ensure there is adequate space in the tower for fitting Air extraction with external motor To minimise noise from the motor in the kitchen, the silencer should be positioned in front of the external motor ...
Electrical connection All electrical work should be undertaken by a suitably qualified and competent person in strict accordance with current national and local safety and building code regulations. Installation, repairs and other work by unqualified persons could be dangerous, for which the manufacturer cannot be held liable.
Activating Con@ctivity 2.0 Activating the rangehood Installing the Con@ctivity 2.0 dongle The cooktop and rangehood must be switched off. In order for the Con@ctivity 2.0 function to be used, the cooktop must be fitted Touch the run-on option control with the Con@ctivity dongle.
Activating Con@ctivity 2.0 Activating the cooktop Activation failed While the rangehood is searching for If connection cannot be established the radio connection, start activating despite activating the Con@ctivity the cooktop. function on the rangehood and More information about this can be cooktop, the function must be found in the Operating instructions deactivated on both appliances and...
1.5 m Weight DA 6690 W 26 kg DA 6690 W EXT 23 kg * For EXT models, the rated load will depend on the type of external motor fitted. Length of connection cable to external motor: 1.9 m Recirculation mode with conversion kit DUW 20 and charcoal filter DKF 12 (optional...
Page 47
Miele Experience Centre South Melbourne: Freemans Bay, Auckland 1011 206-210 Coventry Street South Melbourne, VIC 3205 Miele Experience Centre Auckland: Miele Experience Centre and Office Sydney: 8 College Hill 3 Skyline Place Freemans Bay, Auckland 1011 Frenchs Forest, NSW 2086 Telephone:...
Page 48
DA 6690 W DA 6690 W EXT en-AU, NZ M.-Nr. 09 730 820 / 01...