Page 1
Operating and Installation instructions Rangehood DA 5960 W, DA 5990 W, DA 5990 W EXT en - AU, NZ To avoid the risk of accidents or damage to the appliance, it is essential to read these instructions before it is installed and used for the first time.
Caring for the environment Disposal of the packing Disposal of your old appliance material or machine The transport and protective packing Electrical and electronic appliances / has been selected from materials which machines often contain materials are environmentally friendly for disposal which, if handled or disposed of and can normally be recycled.
Any other usage is at the owner's risk. requirements. Inappropriate use Miele cannot be held liable for damage can, however, lead to personal injury resulting from incorrect or improper use and damage to property.
Faulty components must only be the data plate correspond to the on-site replaced by genuine Miele original electricity supply, otherwise the parts. The manufacturer can only appliance could be damaged. Consult guarantee the safety of the appliance a qualified electrician if in any doubt.
Page 6
These models may only be combined with a Miele external motor. This rangehood must not be installed and operated in mobile installations (e.g. on a ship).
Page 7
Warning and Safety instructions In order to ensure safe operation, and to prevent gases given off by the heating appliances from being drawn back into the room when the extractor and the heater are in operation simultaneously, an underpressure in the room of 0.04 mbar (4 pa) is the maximum permissible.
Warning and Safety instructions Correct use Do not use the rangehood without the filters in place. This way you will Never use an open flame beneath avoid the risk of grease and dirt getting the rangehood. To avoid the danger of into the appliance and hindering its fire, do not flambé...
Safety regulations prohibit the fitting of a rangehood over solid fuel stoves. All ducting, pipework and fittings must be of non-flammable material. These can be obtained from Miele or from builders' merchants. The appliance must not be connected to a chimney or vent flue which is in use.
Page 11
Description of the appliance a Telescopic extension piece b Tower c Control unit d Cooktop lighting e Recirculation grille (only for recirculation mode) f Canopy g Charcoal filter (special accessory for recirculation mode) h Grease filter i On/Off touch control for the fan j Touch controls to select the fan power level k On/Off touch control for the...
Modes of operation ..air recirculation: The rangehood works with (available as an optional extra with a ..air extraction: conversion kit and charcoal filter: see "Technical Data") The air is drawn in, cleaned by the grease filter and then directed outside.
Operation To switch the fan on To switch the fan off ^ Press the On/Off touch control to switch the fan off. It is advisable to run the fan for a few minutes after cooking has finished to ^ Press the On/Off touch control. neutralise any lingering odours in the air, whether you are using air extraction The fan will come on at power level lI.
Page 14
Operation ^ Press the + touch control to activate Automatic switch-off of the Intensive setting the automatic switch-off. The indicator lamps for fan power You can set the Intensive setting so that levels I and IV will now light up it only runs for 10 minutes before constantly.
Casing A specially designed stainless steel General notes detergent which prevents resoiling can be purchased from the Miele Spare The surfaces and controls are Parts Department. Apply sparingly with susceptible to scratches and a soft cloth following the instructions on abrasion.
Cleaning and care Controls An oversaturated filter is a fire The controls may suffer hazard. discolouration or damage if soiling is left on them for too long. Remove soiling straight away. Observe the General notes on cleaning earlier in this section. Do not use stainless steel cleaning agents on the controls.
Page 17
^ Do not wash at more than 65 °C. If a ^ insert a small screwdriver blade into Miele dishwasher is being used, the slit to disengage the clip. select the Sensor wash programme. ^ Use a mild dishwasher detergent.
Replacement charcoal filters can be obtained from your Chartered Agent or the Miele Spare Parts Department or via the internet on ^ Insert the charcoal filter into the back www.miele-shop.com (depending on of the charcoal filter frame a, then country).
Cleaning and care Changing a halogen lamp ^ Before any cleaning or maintenance work, disconnect the cooker hood from the mains supply. Ensure that: – it is switched off at the isolator, or – it is switched off at the wall socket and the plug is withdrawn, or –...
650 mm cause problems when trying to remove If this rangehood is installed above a the grease filter. This depends on the Miele Wok CS 1028 CombiSet height and the thickness of the installed appliance, a minimum safety backsplash. distance of 760 mm must be maintained between the burner and the lower edge of the rangehood.
Page 22
Appliance dimensions – If positioned too high, extraction will Drill holes be inefficient. – The height of the cooking appliance below must be taken into account when planning the installation height of the rangehood. For a pre-installation on a back wall refer to the drilling distances in the drawing above (screws ø...
Installation Dismantling Before installation, it is important to Should the appliance ever need to be read the information given on the dismantled, follow the installation following pages as well as the instructions in reverse order as "Appliance dimensions" and the described on the installation sheet.
Page 25
Installation a 3 protective sheets for use when fitting the tower. b 1 exhaust connection for exhaust 2 x M 6 self-tapping nuts ducting C 150 mm. for securing the appliance. c 1 reducing collar for exhaust ducting C 125 mm. d 1 non-return flap 2 screws 3,9 x 7,5 mm for fitting into the exhaust connection...
Connection for air extraction – Only use smooth pipes or flexible Important: To avoid the danger of hoses made from non-flammable toxic fumes, please observe the materials for the extraction ducting. Warning and Safety instructions. – When using an external motor, make This is especially crucial when using sure that the exhaust ducting is the rangehood at the same time as...
Connection for air extraction Condensate trap – If the exhaust air is to be ducted into the open air, the installation of a (optional accessory) telescopic wall vent or roof vent (available as an optional accessory) is recommended. – If the exhaust air is to be ducted into a vent flue, the ducting must be directed in the flow direction of the flue.
Connection for air extraction Silencer ...with air extraction: (optional accessory) The silencer not only reduces noise from the motor outside the house, but also sounds from outside (e.g. traffic noise). For this reason the silencer must be positioned as close as possible to the ducting exit a.
Electrical connection If the switch is not accessible after All electrical work should be installation, an additional means of undertaken by a suitably qualified disconnection must be provided for all and competent person in strict poles. accordance with current national For extra safety, it is advisable to install and local safety regulations.
Operation with Control module DSM 400 The Miele DSM 400 can be used to Installation combine the rangehood with other components. It enables the following: Potential free connection This is used for controlling another appliance with the help of the rangehood's On/Off button s.
– your Miele Chartered Agent or – Miele You will find the telephone number and address of Miele on the back cover of the manual. Please quote the model and serial number when contacting Miele. These...