Page 1
Operating and installation instructions Cooker hood DA 5960 W, DA 5990 W, DA 5990 W EXT en - GB To avoid the risk of accidents or damage to this appliance, it is essential to read these instructions before it is installed and used for the first time.
Caring for the environment Disposal of the packing material Disposal of your old appliance The transport and protective packing Electrical and electronic appliances has been selected from materials which often contain materials which, if are environmentally friendly for handled or disposed of incorrectly, disposal, and should be recycled.
Any other usage is not supported by requirements. Inappropriate use the manufacturer and could be can, however, lead to personal injury dangerous. Miele cannot be held liable and damage to property. for damage resulting from incorrect or improper use or operation.
The electrical safety of this Faulty components must only be appliance can only be guaranteed if it replaced by genuine Miele original is correctly earthed. It is most important parts. The manufacturer can only that this basic safety requirement is...
Page 6
These models may only be combined with a Miele external motor. This appliance must not be used in a non-stationary location (e.g. on a ship). Great care should be taken when...
Page 7
The Miele DSM 400 control module only be switched on when the heating offers the possibility of combining other appliance is switched off or vice versa.
Warning and Safety instructions Correct use Do not use the cooker hood without the filters in place. This way you will Never use an open flame beneath avoid the risk of grease and dirt getting the cooker hood. To avoid the danger into the appliance and hindering its of fire, do not flambé...
Safety regulations prohibit the fitting of a cooker hood over solid fuel stoves. All ducting, pipework and fittings must be of non-flammable material. These can be obtained from the Miele Spare Parts department or from builders' merchants. The appliance must not be connected to a chimney or vent flue which is in use.
Page 11
Guide to the appliance Telescopic extension piece Tower Controls Hob lighting Recirculation grille (only for recirculation mode) Canopy Charcoal filter (accessory required for recirculation mode) Grease filter On/Off control for the fan Controls to select fan power level On/Off control for hob lighting...
Modes of operation . . . air recirculation: The cooker hood works with (requires a conversion kit and charcoal filter, available as optional extras: see "Technical Data") . . . air extraction: The air is drawn in and cleaned first by The air is drawn in, cleaned by the the grease filter and then by a charcoal grease filter and then directed outside.
If the cooker hood has been connected to a window contact To switch the lighting on and off switch via the Miele DSM 400 control The hob lighting can be switched on module, then the fan cannot be and off independently of the fan.
Page 14
Operation ^ Press the + control to activate the Automatic switch-off of the Intensive setting automatic switch-off. The indicator lamps for fan power You can set the Intensive setting so that levels I and IV will now light up it only runs for 10 minutes before constantly.
Cleaning and care A range of Miele branded cleaning and Do not use: conditioning products is available to – cleaning agents containing soda, order from Miele (see back page for acids, chlorides or solvents, details) or via the internet at www.miele-shop.com.
Cleaning and care Controls An oversaturated filter is a fire The controls may suffer hazard. discolouration or damage if soiling is left on them for too long. Remove soiling straight away. Observe the General notes on cleaning earlier in this section. Do not use stainless steel cleaning agents on the controls.
Page 17
^ Do not wash at more than 65° C. If a ^ Should the grease filter be put back Miele dishwasher is being used, upside down: select the Sensor wash programme. Insert a small screwdriver into the slit to disengage it.
It is fitted in the canopy above the grease filter. New charcoal filters can be purchased from your Miele dealer, from the Miele Spare Parts Department or via the internet at ^ Insert the charcoal filter into the front www.miele.co.uk.
Cleaning and care Changing a halogen lamp ^ Before any cleaning or maintenance work, disconnect the cooker hood from the mains supply. ^ Remove the grease filter. ^ Remove the charcoal filter if the cooker hood is being used in recirculation mode.
650 mm above gas hobs and cookers. If this cooker hood is installed above a Miele Wok CS 1028 CombiSet appliance, a minimum safety distance of 760 mm must be maintained between the burner and the lower edge of the cooker hood.
Page 22
Appliance dimensions – When deciding on the safety Drilling diagram distance between the hob and cooker hood, please note that a distance of 650 mm above electric cookers/hobs may be preferable to give more working space under the hood. – Account should also be taken of the height of the person who will be using the hood most often.
Installation Dismantling Before installation, it is important to Should the appliance ever need to be read the information given on the dismantled, follow the installation following pages as well as the instructions in reverse order as "Appliance dimensions" and the described on the installation sheet.
Page 25
Installation 3 protective sheets for use when fitting the tower. 1 exhaust connection for exhaust 8 screws 5 x 40 mm and ducting C 150 mm. 8 x S 8 plugs 1 reducing collar for securing the wall brackets. for C 125 mm exhaust ducting. The screws and plugs are 1 non-return valve designed for use in solid walls only.
Connection for air extraction – Only use smooth pipes or flexible Important: To avoid the danger of hoses made from non-flammable toxic fumes, please observe the materials for the extraction ducting. Warning and Safety instructions. – When using an external motor, make This is especially crucial when using sure that the exhaust ducting is the cooker hood at the same time as...
Connection for air extraction Condensate trap – If the exhaust air is to be ducted into the open air, the installation of a (optional accessory) telescopic wall vent or roof vent (available as an optional accessory) is recommended. – If the exhaust air is to be ducted into a vent flue, the ducting must be directed in the flow direction of the flue.
Connection for air extraction Silencer ...with air extraction: (optional accessory) The silencer not only reduces noise from the motor outside the house, but also sounds from outside (e.g. traffic noise). For this reason the silencer must be positioned as close as possible to the ducting exit ...in recirculation mode: The silencer needs to be positioned...
Electrical connection If the switch is not accessible after All electrical work should be installation (depending on country), an undertaken by a suitably qualified additional means of disconnection must and competent person in strict be provided for all poles. accordance with current national For extra safety it is advisable to protect and local safety regulations the appliance with a suitable residual...
Operation with Control module DSM 400 The Miele DSM 400 Control module can If the control module is disconnected be used to combine the cooker hood in order to operate the cooker hood with other components. without the window contact switch It enables the following: (e.g.
Operation with Control module DSM 400 Connection to a light switch The control module can be used to switch on the cooker hood lighting via a light switch in the house. Installation The tower needs to be removed before the control module can be fitted to the fan unit.
In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – Your Miele Dealer / Chartered Agent – The Miele Service Department (see back cover for address). When contacting your Dealer or Miele, please quote the model and serial number of your appliance.