Operating instructions S 7000 series vacuum cleaners To avoid the risk of accidents or damage to the appliance, it is essential to read these instructions before using it for the first time. en - GB These operating instructions apply to the...
Caring for our environment Disposal of packing material Disposing of your old appliance The packaging is designed to protect the vacuum cleaner from damage Before disposing of your old appliance during transportation. The packaging remove the dustbag and all the filters materials used are selected from and dispose of them with your normal materials which are environmentally...
Guide to the appliance The illustration shows the maximum number of features available on these Miele vacuum cleaners.
Page 5
Guide to the appliance a Upper cable hook for mains cable b Suction hose holder c Suction hose with handle d Release button e Telescopic tube f Dust compartment filter (for motor protection) g Telescopic tube release button h Vacuum cleaner foot release i Exhaust filter * j Exhaust filter compartment k Electrobrush...
Page 6
Guide to the appliance Depending on model, your vacuum cleaner will be fitted as standard with one of the following control units: Vacuum cleaners with a rotary selector dial a Vacuum cleaner in-operation indicator light b Electrobrush in-operation indicator light c Rotary suction power selector Vacuum cleaners with + / - buttons a Automatic button...
Warning and Safety instructions This vacuum cleaner complies with statutory safety requirements. Improper use can, however, lead to personal injury and damage to property. To avoid the risk of accidents and damage to the vacuum cleaner, please read these instructions carefully before using it for the first time.
Page 8
While the vacuum cleaner is under guarantee, repairs should only be undertaken by a Miele authorised service technician. Otherwise the guarantee will be invalidated. Repairs should only be carried out by a Miele authorised service technician. Repairs and other work by unqualified persons can cause considerable danger to users.
Page 9
Do not use the vacuum cleaner if the cable is damaged. If the cable is damaged the complete cable unit must be replaced. For safety reasons this work must be done by the Miele Service Department or a Miele authorised service technician.
Page 10
Only use genuine dustbags, filters, accessories and optional accessories with the "Original Miele" logo on them. This will ensure optimum performance of the appliance throughout its life. Miele cannot be held liable for damage caused by incorrect use or operation or by non-compliance with these Warning and Safety instructions.
Preparing for use Assembling the cleaner ^ Raise the vacuum cleaner into the vertical position. ^ Insert the handle into the vacuum cleaner until it clicks into position.
Preparing for use Activating the exhaust filter change indicator Depending on model, your vacuum cleaner will be fitted as standard with one of the following exhaust filters: a Air Clean b ActiveAirClean 30 (black) c HEPA AirClean 30 (white) If your vacuum cleaner is fitted with filter b or c, the exhaust filter change indicator needs to be activated.
Page 13
Preparing for use ^ Press the exhaust filter change indicator ~. ^ After approx. 10 - 15 seconds a thin red stripe will appear in the left hand side of the display. ^ Close the exhaust filter compartment lid. The exhaust filter change indicator The exhaust filter change indicator shows the remaining functional life of the exhaust filter.
Using the cleaner Unwind the mains cable The lower cable hook can be turned in either direction. ^ Turn it upwards to release the cable. Winding up the mains cable When the cleaner is not in use, the cable can be wound around the two cable hooks.
Using the cleaner Releasing the vacuum cleaner ^ Step on the foot switch and tilt the cleaner to a comfortable position for vacuuming. Switching on and off Important: please observe the flooring manufacturer's cleaning and care instructions. ^ Press the On / Off button on the handle.
Page 16
Using the cleaner -/+ buttons Some models also have symbols on the control unit which indicate the type of use the settings are suitable for: a - curtains, lightweight fabrics b - upholstery, cushions c - carpets, rugs and runners ( - for daily energy-saving vacuuming.
Page 17
Using the cleaner Automatic suction power regulation (on vacuum cleaners with + / - buttons) The suction power automatically adjusts itself to suit the type of flooring or carpet being vacuumed. ^ Press the Automatic button. The button lights up yellow. To stop using the automatic setting simply press the Automatic button again.
Using the cleaner Vacuuming using the suction hose Warning: Do not use the suction hose at head level to avoid the risk of injury, e.g. to eyes and ears. Warning: It is not advisable to vacuum directly with the suction hose, i.e.
Using the cleaner Vacuuming using the telescopic tube Warning: Do not use the telescopic tube at head level to avoid the risk of injury, e.g. to eyes and ears. Warning: To prevent the risk of injury when vacuuming the stairs ensure the cleaner is placed in a stable position at the bottom of the stairs, or on one of the lower steps.
Using the Electrobrush Recommended use Important: please observe the flooring manufacturer's cleaning and care instructions. The Electrobrush is particularly suitable for intensive vacuuming of carpets which are subject to hard wear. It is very effective at removing deep seated dirt and preventing areas of frequent use being trodden into a path.
Using the Electrobrush Switching the Electrobrush on and off The roller on the Electrobrush is driven by a motor which can be switched on and off. ^ Press the Carpet button on the handle. The Electrobrush will switch on. The Electrobrush in-operation indicator light in the control unit will light up yellow.
Using the accessories supplied The following accessories are stowed at the back of the cleaner. a Upholstery nozzle For cleaning upholstery, mattresses, cushions, curtains, covers etc. b Crevice nozzle, 300 mm For cleaning in folds, crevices or corners and narrow gaps. c Dusting brush with natural bristles For cleaning skirting boards, ornate or carved articles, etc.
Miele retailer, work. Switch off at the wall socket from Miele and via the internet at: and withdraw the plug. The Miele filter system consists of three filters which must be replaced from time to time to ensure that your vacuum cleaner performs efficiently.
(see possible reasons for this below). Miele dustbags are disposable and intended to be used only once. Do not attempt to re-use as suction would be reduced by the blocked pores.
Maintenance Replacing the dustbag ^ Raise the vacuum cleaner into the vertical position. ^ Raise the release button and open the lid to its resting position. ^ Pull on the tab at the side of the collar and swing the bag up away from the suction socket before taking it out of its holder.
Replace this filter every time you start a new packet of dustbags. A dust compartment filter is supplied with every packet of Miele dustbags. How to change the dust compartment filter ^ Open the dust compartment lid. ^ Remove the dustbag.
Air Clean filter Replace this filter every time you start a new packet of Miele dustbags. An Air Clean exhaust filter is supplied with every packet of Miele dustbags. b ActiveAirClean 30 filter (black)
Maintenance Replacing the Air Clean filter Do not use more than one exhaust filter at a time. ^ Open the exhaust filter compartment lid. ^ Remove the filter grille. ^ Open the filter grille and remove the used Air Clean filter by one of the clean, unsoiled sections.
Maintenance Replacing an ActiveAirClean 30 filter or an HEPA AirClean 30 filter Do not use more than one exhaust filter at a time. ^ Open the exhaust filter compartment lid. ^ Remove the exhaust filter. ^ Insert the new exhaust filter and press the exhaust filter change indicator ~ ^ After approx.
Maintenance Replacing one type of exhaust filter with another Depending on model, your vacuum cleaner will be fitted as standard with one of the following exhaust filters: a Air Clean filter b ActiveAirClean 30 filter (black) c HEPA AirClean 30 filter (white) Please note Do not use more than one exhaust filter at a time.
Maintenance Maintenance indicator with reset button [ If your vacuum cleaner is fitted with a maintenance indicator, this will light up after approx. 50 operating hours, or approx. one year of average use. The degree of soiling of the motor protection filter and the exhaust filter should be checked at this time.
Maintenance Removing threads and hair from the Electrobrush ^ Switch the Electrobrush and the vacuum cleaner off, switch it off at the wall socket and remove the plug. ^ Release the vacuum cleaner and place it flat on the floor. ^ Turn the vacuum cleaner over.
Page 33
Maintenance The suction hose can be opened up to clean out any heavy soiling or blockages. Any large particles inside it can then be easily removed. ^ Raise the vacuum cleaner into the vertical position. ^ Press the release button on the telescopic tube and remove the suction tube handle.
Cleaning and care Warning: Always disconnect the vacuum cleaner from the electrical supply before cleaning it. Switch off at the wall socket and remove the plug. Vacuum cleaner and accessories External surfaces of the vacuum cleaner and of the accessories can be cleaned with a dry or a slightly damp cloth, or with a proprietary cleaner suitable for plastic.
– your Miele retailer ^ Switch the Electrobrush and the vacuum cleaner off, switch it off at – Miele (see back cover for contact the wall socket and withdraw the details). plug. ^ Remove the blockage.
Miele accessories, including awkward corners. floorheads, filters and dustbags are available to order through your Miele Hand-held Turbobrush retailer, Miele or online at: The hand-held Turbobrush is intended for vacuuming upholstery, mattresses, car seats, carpeted stairs etc.
Page 37
Optional accessories ActiveAirClean 30 exhaust filter (SF-AA 30) This filter absorbs odours from the dirt collected in the dustbag. HEPA AirClean 30 exhaust filter (SF-HA 30) Excellent filtration level for very clean exhaust air. This filter is particularly suitable for allergy sufferers. Filter grille The filter grille is required if you wish to fit an Air Clean filter instead of an...
Electrical connection for the UK All electrical work should be carried out by a suitably qualified and competent person in strict accordance with current national and local safety regulations (BS 7671 in the UK). The voltage and connected load are given on the data plate located underneath the vacuum cleaner.
Page 40
Alteration rights reserved / S 7000 / 2813 M.-Nr. 09 753 050 / 00...