Installation Instructions Combi-Steam Oven DGC 4084 XL DGC 4086 XL en - US, CA To prevent accidents and appliance damage read these instructions before installation or use. M.-Nr. 09 064 870...
Installation, repair and maintenance system. It is imperative that this basic work should be performed by a Miele safety requirement be met. If there is authorized service technician. Work by any doubt, have the electrical system of...
Installation Miele appliances can be installed flush or proud. Discuss your installation requirements with your architect, designer or installer. Dimension details of the appliance front 7/8" 22*/23** 7/8" 47,5...
Page 5
Installation Dimension to allow the control panel to open and close The area in front of the control panel must not be blocked by anything (such as a door handle) this would hinder the control panel from opening and closing.
Installation Cut-out for venting the combi-steam oven Installation in a tall cabinet 5 / 8 " 5 / 8 " ( 4 0 m ( 5 0 0 m To ensure that the combi-steam oven has adequate ventilation, the following cut-outs measuring 19 "...
Page 7
Installation Installation under a countertop 5 / 8 " m m ) ( 5 0 0 8 " To ensure that the combi-steam oven has adequate ventilation, the following cut-outs measuring 19 " x 1 " (500 x 40 mm) must be provided: in the appliance support shelf in the bottom of the cabinet space below it...
Appliance and installation dimensions Installation in a tall cabinet ( 5 0 0 m m ( 4 0 Combi-steam oven b Installation niche Terminal block Outlet or junction box This should be accessible after the appliance has been installed. Power cord (5 ft.) * Appliances with glass front / ** Appliances with metal front...
Appliance and installation dimensions Installation under a countertop If the appliance is be installed under a cooktop, observe the installation instructions for the cooktop and its installation height. m m ) ( 5 0 0 ( 4 0 Combi-steam oven Installation niche Terminal block Outlet or junction box...
Appliance and installation dimensions Installation in combination with an oven ( 5 0 0 m m ( 4 0 ( 5 4 Combi-steam oven Installation niche Terminal block Outlet or junction box This should be accessible after the appliance has been installed. Power cord (5 ft.) Oven * Appliances with glass front / **...
Appliance and installation dimensions Installation in combination with ESW 408x-14 ( 5 0 0 m m ( 4 0 Combi-steam oven Installation niche Terminal block Outlet or junction box This should be accessible after the appliance has been installed. Power cord (5 ft.) Built-in plate warmer / built-in food warmer * Appliances with glass front / ** Appliances with metal front...
Appliance and installation dimensions Installation in combination with ESW 408x-14 BRWS ( 5 0 0 m m ( 4 0 Combi-steam oven Installation niche Terminal block Outlet or junction box This should be accessible after the appliance has been installed. Power cord (5 ft.) Built-in plate warmer / built-in food warmer * Appliances with glass front / **...
Appliance and installation dimensions Installing the appliance ^ Push the appliance into the cabinet niche and align it. The device must be level, so that the steam generator can operate properly. Deviation from a horizontal position should not exceed 2°. ^ Secure the appliance by screwing the two 3.5 x 25 mm wood screws (supplied) into the vertical strips on either side of the housing.
WARNING: please consult a licensed electrician THIS APPLIANCE MUST BE or contact Miele’s Technical Service GROUNDED! Department. Installer: Please leave these instructions with the consumer.
Page 16
Alteration rights reserved / 1013 M.-Nr. 09 064 870 / 03 INFORMATION IS SUBJECT TO CHANGE. PLEASE REFER TO OUR WEBSITE TO OBTAIN THE MOST CURRENT PRODUCT SPECIFICATIONS, TECHNICAL & WARRANTY INFORMATION.