Table of Contents
Advertisement
Problem solving guide
Fault message after a programme has been interrupted.
Problem
Drainage See
Water intake See
Waterproof system.
Turn off Ser-
vice
Service Fault F
To switch off the fault message: Turn the programme selector to the position
and switch the washing machine off.
54
Cause and remedy
The water outlet is blocked or restricted.
The drain hose has been fixed too high.
Clean the drain filter and the drain pump.
The maximum delivery head is 1 m.
The water inlet is blocked or restricted.
Check whether the stopcock has been properly
opened.
Check whether the inlet hose is kinked.
Check whether there is sufficient water pressure.
The filter in the water inlet is blocked.
Clean the filter.
The drain pump is activated for 2 minutes. The wash-
ing machine door is then released. Wait for the drain
pump to stop before switching the machine off.
The water protection system has reacted.
Close the stopcock.
Call Miele.
There is a fault.
Disconnect the washing machine from the mains
electricity supply, either by switching it off at the
wall socket and withdrawing the plug, or by dis-
connecting it at the circuit breaker.
Wait at least 2 minutes before reconnecting the
washing machine to the mains electricity supply.
Then switch the washing machine on again.
Restart the programme.
If the fault message appears again, contact Miele.
Advertisement
Table of Contents
