PRODUCT DATA SHEETS ... WARRANTY ONE-YEAR FULL WARRANTY ON REFRIGERATOR For one year from the date of purchase, when this refrigerator is operated and maintained according to instructions attached to or furnished with the product, Sears will repair this refrigerator, free of charge, if defective in material or workmanship.
IM PORTANT SAFETY INSTRUCTIONS WARN IN G: To reduce the risk of fire, electric shock, or injury when using your refrigerator, follow these basic precautions: Plug into a grounded 3 prong outlet.
To ensure proper ventilation for your refrigerator, allow for _/2in. (1.25 cm) space on each side and at the top. When installing your refrigerator next to a fixed wall, leave 2 in. (5.08 cm) minimum on each side (depending on your model) to allow for the door to swing open.
Donot usean extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. Before you move your refrigerator into its final location, it is important to make sure you have the proper electrical connection: Recommended grounding method A 115 Volt, 60 Hz., AC only 15 or 20 ampere fused, grounded...
TOOLS N EEDED: 1/4 i n.,1/2 in.,and%6in.hex-head socket wrenches, aflat-head screwdriver anda Phillips screwdriver. IMPORTANT: Before y oubegin, turn therefrigerator adjustable door o rutility bins from doors. Disconnect power before removing doors. Reconnect both ground wires before operating, Failure to do so can result in death or electrical shock. Top Left Hinge 1.
Page 7
Lift trim pieces off shoulder screws (see Graphic 1). 2. Remove handle screws and handles. 3. Move refrigerator into place. Replace handles as shown (see Graphic 1). Door Removal Electrical Shock Hazard Disconnect power before removing doors.
Door Closing 1. Move the refrigerator into its final position. Place a level inside the refrigerator at the back of the top shelf (see Graphic 6). Locate the leveling screws behind the base grille of the refrigerator on either side.
Depending on your model, you may want to select the maximum ice feature to increase the production Your new refrigerator may make sounds that your old one didn't make. Because the sounds are new to you, you might be concerned about them. Most of the new sounds are normal. Hard surfaces, such as the floor, walls, and cabinets, can make the sounds seem louder.
• Wait 24 hours after you turn on the refrigerator before you put food into it. If you add food before the refrigerator has cooled completely, your food may spoil. Adjusting the Refrigerator and Freezer Controls to a colder setting will not cool the compartments any faster.
The water dispenser If you did not flush the water system when the refrigerator was first installed, press the water dispenser bar with a glass or jar until you draw and discard 2 to 3 gal. (8 to 12 L) or approximately 6 to 7 minutes of water after water begins dispensing.
Non-indicator water filter (on some models) If your refrigerator does not have the water filter status light, you should change the water filter cartridge every 6 to 9 months depending upon your usage. If the water flow to the water dispenser or ice maker decreases noticeably before 6 months have passed, replace the water filter cartridge more often.
Maximum Ice Production (on some models): In maximum ice production, the ice maker should produce approximately to 14 batches of ice in a 24-hour period. If your refrigerator has the maximum ice production feature, push the switch to Filter MAX.
Your model may have glass or wire shelves. Store similar foods together and adjust the shelves to fit different heights. This reduces the time the refrigerator door is open and saves energy. Slide-out Shelves (on some models) To remove and replace a shelf in a metal frame: 1.
3. Replace back of meat drawer cover frame into supports or slides on side walls of the refrigerator and lower or slide the front of the cover frame into place. 4. Slide rear of glass insert into cover frame and lower front into place.
1. Remove the rack by pulling it straight out from the shelf. Replace the rack by sliding it in between the shelf and the wall of the refrigerator. NOTE: For long-term storage, place eggs in a covered container or in their original carton on an interior shelf.
(or auto paste wax) with a clean, soft cloth. Do not wax plastic parts. NOTE: To keep your Stainless Steel refrigerator looking like new and to remove minor scuffs or marks, it is suggested that...
Replace the light shield by inserting the left tab into the freezer wall. Align top tab with screw hole and replace screw. If the power will be out for 24 hours or less, keep both refrigerator doors closed to help food stay cold and frozen.
8. Take out all removable parts, wrap them well, and tape them together so they don't shift and rattle during the move. 9. Depending on the model, raise the front of the refrigerator so it rolls more easily OR screw in the leveling legs so they don't scrape the floor.
Page 20
Is there a water filter installed on the refrigerator? The filter may be clogged or installed incorrectly. Check the filter installation instructions to ensure that the filter was installed correctly and is not clogged. If installation or clogging is not a problem, call a technician or other qualified person.
Page 21
Are the air vents blocked in either compartment? prevents the movement of cold air from the freezer to the refrigerator. Remove any objects from in front of the air vents. See the "Ensuring Proper Air Circulation" location of air vents.
1-800-361-6665. Replacement To order stainless steel cleaner or replacement filters, call and instructional 1-800-4MY-HOME listed below or contact your authorized Kenmore dealer. Stainless Order Part #D22 M40083 R Base grille water filter cartridges: Cyst Cartridge: Order Part #9902 (WF-NLC250 and WF-LC400) online.