- GB These operating instructions apply to standard models S 6710 - S 6790 as well as to other S 6000 vacuum cleaners which are distinguished by names rather than numbers.
Contents Caring for the environment Description of the appliance Warning and Safety instructions Preparing for use Using the accessories supplied Correct use Mains cable ............17 To switch on and off.
Caring for the environment Disposal of packing material Disposal of your old appliance The transport and protective packing Before disposing of your old appliance has been selected from materials which remove the dustbag and all the filters are environmentally friendly for disposal and dispose of them with your normal and should be recycled.
Description of the appliance The illustration shows the maximum number of features available on these Miele vacuum cleaners. Certain models are supplied as standard with the following accessories which are not illustrated on this page. – Classic Allergotec floorhead – Turbobrush...
Page 5
Description of the appliance a Handle b Suction power selector + / - c Stand-by button - for pauses in vacuuming d LED e Release button f Telescopic or triscopic tube * g Release buttons for the telescopic or triscopic tube * h Dust compartment release button i Floorhead * j Carrying handle...
Warning and Safety instructions This vacuum cleaner meets statutory safety requirements. Improper use can, however, lead to personal injury and damage to property. To avoid the risk of accidents and damage to the vacuum cleaner, please read these instructions carefully before using it for the first time. They contain important information on its safety, operation and maintenance.
Page 7
Warning and Safety instructions The vacuum cleaner is not intended for outdoor use. The vacuum cleaner must only be used for domestic household purposes to vacuum dry floor surfaces. It must not be used on people or animals. Any other use, modification or alteration is not supported by the manufacturer and could be dangerous.
Page 8
While the vacuum cleaner is under guarantee, repairs should only be undertaken by a service technician authorised by Miele. Otherwise the guarantee will be invalidated. Do not pull or carry the appliance by the cable, and be careful not to damage the cable when withdrawing the plug from the socket.
Page 9
If the cable is damaged it must be replaced together with a complete cable rewind. For safety reasons this work must be done by the Miele Service Department or a Miele authorised service technician. There is a metal inlay underneath the handle which is designed to protect the user from electrostatic discharges.
Page 10
Warning and Safety instructions Do not vacuum up any water, liquid or damp dirt. Wait until any freshly cleaned or shampooed carpets or floor coverings are completely dry before attempting to vacuum. Do not vacuum toner dust. Toner, such as that used in printers and photocopiers, can conduct electricity.
Page 11
Accessories Miele accessories including floorheads, filters and dustbags are available to order from your Miele retailer, the Miele Spare Parts Department or online at www.miele-shop.com. To avoid the risk of injury when vacuuming with a Miele Turbobrush, do not touch the rotating roller brush.
Preparing for use Attaching the suction hose ^ Insert the hose connector into the socket until it clicks into position. To do this, line up the guides on the two pieces. Removing the suction hose from the cleaner ^ Press the release buttons at the side of the hose connector, and lift the hose from the socket.
Page 13
Preparing for use Connecting the radio control handle to the suction tube ^ Insert the handle into the suction tube until it clicks into position. To do this, line up the guides on the two pieces. ^ To release the handle from the suction tube, press the release button and pull the handle away from the suction tube.
Page 14
It can also be used with the brush protruding to vacuum hard flooring. For hard flooring, such as stone and parquet, we recommend using one of the special Miele floor brushes (see "Optional accessories").
Page 15
Preparing for use Adjusting the standard floorhead It is important to observe the flooring manufacturer's cleaning and care instructions. Depending on model, the floorhead will have the following symbols: – ö and ä – % and ) Vacuum carpets and rugs with the brush retracted: ^ Press the ö...
Using the accessories supplied The following accessories are supplied: a Dusting brush with natural bristles For cleaning skirting boards, ornate or carved objects. The head can be swivelled to adjust the angle. b Upholstery nozzle For cleaning upholstery, mattresses, cushions, curtains, covers etc. c Crevice nozzle For cleaning in folds, crevices or corners.
Correct use Mains cable Unwinding the cable ^ Pull the mains cable out to the required length (max. approx. 6.5 m). Warning: If vacuuming for longer than 30 minutes, the mains cable must be pulled out to its fullest extent. Otherwise there is a danger of overheating and damage.
Correct use To switch on and off ^ Step on the On/Off foot control s. The standy-by indicator - on the vacuum cleaner will light up. The vacuum cleaner can be switched on in three ways. The stand-by indicator on the vacuum cleaner will then go out.
Correct use Adjusting the suction power The suction power can be regulated to suit the type of flooring. The higher the setting the more powerful the suction. Reducing the suction power reduces the amount of effort required to manoeuvre the floorhead. min.
Page 20
Correct use Vacuuming ^ When vacuuming, pull the cleaner behind you on its wheels. You can stand it upright for vacuuming stairs and curtains etc. Warning: When vacuuming especially fine dust, e.g. sawdust, sand, plaster, flour, talcum powder etc., electrostatic charges build up naturally.
Correct use Interrupting operation To pause the vacuum cleaner during operation: ^ Press the stand-by button - on the handle. Warning: The stand-by button is designed to pause the vacuum cleaner for short periods of time whilst vacuuming. After vacuuming, the vacuum cleaner must be switched off and unplugged from the mains electricity supply.
Setting down, transportation and storage Parking system for pauses in vacuuming The parking system allows you to conveniently park the vacuum cleaner during pauses. ^ Slot the floorhead into the parking attachment at the back of the vacuum cleaner. If the vacuum cleaner is on a sloping surface, e.g.
Miele Dealer, work. Switch off at the wall socket from Miele or online at: and unplug it. The Miele filter system consists of three filters: – Dustbag – Exhaust filter Only use original Miele F/J/M dustbags –...
(see possible reasons for this below). Miele dustbags are disposable and designed to be used only once. Dispose of the dustbag when it is full. Do not attempt to reuse them as suction would be reduced.
Maintenance and care Replacing the dustbag ^ Press the release button for the dust compartment lid and raise the lid as far as it will go. The dustbag has a closing flap which closes automatically when the dust compartment lid is raised to prevent any dust escaping.
The filter change indicator light is irrelevant if an Air Clean filter a is fitted, as long as it is replaced every time a new packet of Miele dustbags is started. The indicator light will go out when the reset button [ is pressed.
Maintenance and care Replacing the Air Clean filter Do not use more than one exhaust filter at a time. ^ Open the dust compartment lid. ^ Release the filter grille and raise it upwards. Grasp the used Air Clean filter by the clean, unsoiled section (see arrow) and take it out.
Maintenance and care Replacing an Active Air Clean filter or an Active HEPA filter Do not use more than one exhaust filter at a time. ^ Open the dust compartment lid. ^ Remove the exhaust filter. ^ Fit the new exhaust filter in position. If you wish to use an Air Clean filter, see "Replacing one type of exhaust filter with another".
The filter change indicator light is irrelevant if an Air Clean filter is being used, as long as it is replaced every time a new packet of Miele dustbags is started. The indicator light will go out when the reset button is pressed.
Replace this filter every time you start a new packet of dustbags. A dust compartment filter is supplied with every packet of Miele dustbags. How to change the dust compartment filter ^ Open the dust compartment lid. ^ Pull the dustbag out by the grip next to the self-closing flap on the collar.
Maintenance and care When to change the battery in the radio control handle Approx. every 18 months. One 3 V battery (CR 2032) is required. The vacuum cleaner can still be used when the battery has run out or if there is no battery fitted.
Press the bearing out, and remove it. c Take out the roller. ^ Remove any threads and hair, replace the roller and refit the bearing. Replacement parts are available from your Miele dealer or from Miele (see back cover for contact details).
Cleaning and care Warning: Always disconnect the vacuum cleaner from the electrical supply for maintenance work and for cleaning. Switch off at the wall socket and unplug it. Vacuum cleaners with textile velvet finish Clean the vacuum cleaner casing with the dusting brush or a slightly damp cloth.
Problem solving guide The vacuum cleaner switches off automatically and the overheating warning light § comes on. A temperature limiter switches the vacuum cleaner off automatically if it gets too hot. The overheating warning light § will then come on to indicate that it has overheated.
After sales service In the event of a fault that you cannot easily remedy, please contact – your Miele Dealer – Miele (see back cover for contact details). Please note that telephone calls may be monitored and recorded for training purposes (UK only).
Miele accessories, including floorheads, filters and dustbags, are Parquet Twister swivel-action available to order through your Miele floorbrush (SBB 300-3) retailer, Miele or online at: This brush is suitable for a variety of hard floor surfaces and has a swivel joint enabling it to get into awkward corners.
Page 37
Optional accessories Hand Turbobrush Turbo Mini Hygiene seal with active charcoal Compact (STB 20) This prevents dust and odours escaping when the suction hose has For cleaning upholstery, mattresses, car seats etc. been removed from the cleaner. Universal brush (SUB 20) Filters For dusting books, shelves, etc.
Electrical connection for the UK All electrical work should be carried out by a suitably qualified and competent person in strict accordance with current national and local safety regulations (BS 7671 in the UK). The voltage and connected load are given on the data plate located underneath the vacuum cleaner.