Page 1
® HOME APPLIANCES 9758646 II " " Freestanding Range Quick Reference Table of Contents: Pages Before you start Product dimensions Cabinet dimensions requirements Tip Over Hazard EUectdcaU requirements A child or adult can tip the range be killed. HnstaHationsteps Connect anti-tip bracket to rear...
Page 2
Mobile home installation Before you start... Tools needed: The installation of this range must conform with the Manufactured Home Follow all factory safety instructions Your safety and the safety Construction and Safety Standard,Title included with your tools. others are very important.
Page 3
Product dimensions When installed in a 24" (61.0 crn) Freestanding Range SUide4n Range base cabinet with 25" (63.5 crn} 30" (76.2 cm) j/_ countertop, front of oven door coo<top w dth protrudes 1-7/8"' (4.8 cm) beyond 24" (61.0 crn} base cabinet. 90"...
Page 4
Slide@ ranges: Electrical requirements countertop If codes permit and a separate ground ff connecting to a four-wire wire is used, it is recommended that preparations system: qualified electrician determine that the This range is manufactured with ground path and wire gauge are in accordance...
Page 5
New start... EJectricaJ connection Excessive Weight Hazard Remove the terminal block cover located on the back of range. Use two or more people to move install range. Failure to do so can result in back or other injury. Tip Over Hazard A child or aduJt can tip the range...
Page 6
Power suppJy cord method: 10. Connect the neutral wire (center wire) NOTE: The bag containing three Use either ring-type terminals aluminum terminal lugs is not used to the center terminal screw on the spade terminals with upturned ends when connecting the range using a to connect the power...
Page 7
Direct wire method: Copper or AJuminum wire IMPORTANT: the aluminum terminal 12. Loosen (do not remove) the 3 slotted NOTE:The bag containing three set screws+ insert the neutral (white) aiuminum terminai Hugs must be used lugs must be assembled to the wire into the hole at the Bottom...
Page 8
Operating position m Make sure the anti-tip bracket Place rack in oven. Place level Move range chose to cabinet on rack, first side to side; then front to is installed: opening. back • Look for the anti-tip bracket securely attached to floor.
Page 9
Check operation You have just finished installing The bottom element should glow red and Check the operation of the indicator light should be on.The your new range.To get the most cooktop eiements: upper element should become hot but efficient use from your range, not glow...
Page 10
Check that the circuit breaker is not deabr from whom purchased Refer to Use and Care Guide. tripped or the house fuse blown. appliance or a KitchenAid-authodzed KitchenAid Customer interaction service company. A KitchenAid- Check that the power supply cord Center wiii answer...