2 electrolux Electrolux. Thinking of you. Share more of our thinking at www.electrolux.com Contents Safety information Unloading the dishwasher Product description Washing programmes Control panel Care and cleaning First use What to do if… Set the water softener Technical data Use of dishwasher salt Hints for test institutes Use of rinse aid...
Page 3
electrolux 3 • Dishwasher detergents can cause chemi- chine. If your dishwasher is damaged con- cal burns to eyes, mouth and throat. Could tact your supplier. endanger life! Comply with the safety in- • All packaging must be removed before structions of the dishwasher detergent use.
4 electrolux Product description Upper basket Worktop Water hardness dial This dishwasher has an internal light that Salt container turns on when the door opens and off Detergent dispenser when it closes. Internal light equipped with led lamp Rinse aid dispenser CLASS 1 in accordance with EN Rating plate 60825-1: 1994 + A1:2002 + A2:2001.
electrolux 5 Control panel On/off button Cancel button (Cancel) Programme selection buttons Multitab button (Multitab) Sanitize button (CarePlus) Delay start button (Delay) Digital display Function buttons Indicator lights Programme indicator lights Indicator lights Comes on when the multitab function is set. Comes on when the sanitize function is set.
6 electrolux • the approximate remaining time of the run- – if the sanitize indicator light stays off, ning programme, the function is not available. • activation/deactivation of the rinse aid dis- Delay start button penser ( ONLY with multitab function ac- You can delay the start of the programme for tive), between 1 and 19 hours.
Page 7
electrolux 7 salts from the water supply, which would The softener should be adjusted according have a detrimental or adverse effect on the to the hardness of the water in your area. operation of the appliance. Your local Water Authority can advise you on The higher the content of these minerals and the hardness of the water in your area.
8 electrolux Use of dishwasher salt 4. Replace the cap making sure that there Warning! is no trace of salt on the screw thread or Only use salt specifically designed for use in on the gasket. dishwashers. All other types of salt not spe- 5.
electrolux 9 40 washing cycles, depending upon the dosage setting. 3. Ensure that the lid is closed after every refill. Clean up any rinse aid spilt during filling with an absorbent cloth to avoid excess foaming during the next wash. According to the finish and drying results ob- tained, adjust the dose of rinse aid by means of the 6 position selector (position 1 minimum...
10 electrolux • Plastic items and pans with non stick coat- • Light items (plastic bowls etc.) must be ings have a tendency to retain water loaded in the upper basket and arranged drops; these items will not dry as well as so they do not move.
Page 11
electrolux 11 The cutlery basket If the size and dimensions of the cutlery do not allow the use of the grid, it can be easily Long bladed knives stored in an upright hidden. position are a potential hazard. Long and/or sharp items of cutlery such as carving knives must be positioned horizontally in the upper basket.
Page 12
12 electrolux Mini cutlery basket Refer to the figures for a correct positioning The upper basket is supplied with a mini cut- of the soft spikes. They can only be posi- lery basket. tioned on right-hand side of the basket. Caution! NEVER PUT KNIVES IN THE Once positioned correctly, press them down MINI CUTLERY BASKET.
electrolux 13 Caution! BEFORE CLOSING THE To lower the basket to the original posi- DOOR, MAKE SURE THAT THE SPRAY tion proceed as follows: ARMS CAN ROTATE FREELY. 1. Pull out the basket until it stops. 2. Carefully lift both sides upwards and then Adjusting the height of the upper basket allow the mechanism to drop back down If washing very large plates you can load...
14 electrolux 2. Fill the detergent dispenser (1) with de- tergent. The marking indicates the dosing levels: 20 = approximately 20 g of detergent 30 = approximately 30 g of detergent. 4. Close the lid and press until it locks in place.
electrolux 15 If the drying results are not satisfac- Rinse aid dispenser deactivated tory we suggest that you: Rinse aid dispenser activated 1. Fill up the rinse aid dispenser with rinse aid. 4. To change the setting, press button B 2.
16 electrolux Warning! Interrupt or cancel a • The light of the programme just ended re- mains on. washing programme in progress ONLY if it's absolutely necessary. • Zero appears in the digital display. Attention! Hot steam may escape The dry system of the appliance has a when the door is opened.
electrolux 17 Washing programmes Washing programmes Programme Degree of Type of load Programme description Sanitize func- soil tion Crockery, Prewash Auto cutlery, pots Main wash up to 45°C or and pans 70°C 1 or 2 intermediate rinses Final rinse Drying Heavy soil Crockery, Prewash...
18 electrolux Care and cleaning Cleaning the filters The filters must be checked and cleaned from time to time. Dirty filters will degrade the washing result. Warning! Before cleaning the filters ensure that the machine is switched off. 1. Open the door, remove the lower basket. 2.
electrolux 19 1. Unplug the appliance and then turn off Moving the machine the water. If you have to move the machine (moving 2. Leave the door ajar to prevent the forma- house etc...): tion of any unpleasant smells. 1. Unplug it. 3.
20 electrolux Contact your local Service Force Centre, So that you always have these numbers at quoting the model (Mod.), product number hand, we recommend you to make a note of (PNC) and serial number (S.N.). them here: This information can be found on the rating Mod.
electrolux 21 Full load: 9 standard place settings Rinse aid setting position 4 (Type III) Testing MUST be carried out with: Arrangement lower basket • NO soft spikes • NO mini cutlery basket. REMOVE these items from the upper basket. Arrangement upper basket without salad-bow Arrangement cutlery basket...
22 electrolux Fitting under a counter (kitchen worktop or sink) Remove all packaging before positioning the machine. If possible, position the machine next to a water tap and a drain. By removing the machine's worktop, you can install it under a close fitting sink unit or a pre- existing top, providing the dimensions of the recess correspond to those shown in the picture.
Page 23
electrolux 23 right to suit the installation by means of the Water drain connection locknut. The locknut must be correctly The end of the drain hose can be connected fitted to avoid water leaks. in the following ways: 1. To the sink outlet spigot, securing it to the Attention! NOT all dishwasher models of underside of the work surface.
24 electrolux Our appliances are supplied with a se- To avoid water leakage after installation curity device to protect against the re- make sure that the water couplings are turn of dirty water back into the machine. tight. If the spigot of your sink has a "no return valve"...