Operating Instructions Dishwasher G 5280 G 5285 en - US, CA To prevent accidents and appliance damage read these instructions before installation or use. M.-Nr. 09 510 220...
If the supplied power cord is appliance as specified in these damaged it must only be replaced by a operating instructions, for cleaning Miele Service technician with a genuine domestic cookware and cutlery. Any Miele power cord. other usage is not supported by the manufacturer and could be dangerous.
Page 5
Do not install this dishwasher beneath a cooking surface, oven or any Installation and repair work should appliance that radiates heat. be performed by a Miele authorized High temperatures from these units service technician. Work by unqualified may damage the dishwasher.
Page 6
IMPORTANT SAFETY INSTRUCTIONS Do not inhale or swallow detergents. Dishwasher detergents contain irritant To reduce the risk of injury, do not and corrosive ingredients. They can allow children to play in, on or near the cause burning in the mouth and throat if dishwasher.
Guide to the dishwasher Upper spray arm (not visible) Triple filter system Cutlery tray (depending on model) Data plate Upper basket Rinse aid reservoir Middle spray arm Dual compartment detergent dispenser Air inlet for drying (depending on model) Salt container Lower spray arm...
Guide to the dishwasher Control panel Check / Refill indicators Program selection Time display Program button , button with indicator light K button (On/Off) with indicator light (Delay start) Turbo button with indicator light This operating instruction manual describes several dishwasher models with different indicated settings.
Caring for the environment Energy saving washing Disposal of the packing material This dishwasher is economical in the use of water and electricity. For best The cardboard box and packaging results follow these tips: protect the appliance during shipping. These materials are biodegradable and ^ For lowest energy consumption you recyclable.
Before using for the first time To open the door To close the door ^ Push the baskets in. ^ Lift the door and push until it clicks into position. ^ Pull the handle to open the door. If the door is opened during operation, the dishwasher will stop running.
Page 11
Before using for the first time Water hardness The water hardness factory setting is 15°d (16 gr/gal). To achieve good cleaning results, the dishwasher needs soft water. Hard If this setting matches your water water results in calcium deposits on hardness you need not read any dishware and in the dishwasher.
Before using for the first time Displaying and setting the water hardness Value to °d gr/gal ^ If the dishwasher is on, press the K in the display button to turn it off. ^ Hold down the Program button. ^ Press the K button to turn the dishwasher on, and hold the Program button down for at least 4 more seconds until the lower right program...
Before using for the first time Filling the salt container Every dishwasher is tested before To achieve good cleaning results, the leaving the factory. Any water dishwasher needs soft water (water that remaining in the machine is from the is low in minerals). Hard water results in final factory test and does not calcium deposits on dishware and in indicate that the machine has been...
Before using for the first time ^ Remove the lower basket from the ^ Immediately run the Express program wash cabinet and unscrew the salt without a load (no Turbo function) to container lid. remove any traces of salt or brine from the wash cabinet.
Before using for the first time Deactivating refill indicators The flashing in the time display indicates whether the refill indicators If you consistently use Tab detergents, are activated or not. you can deactivate the refill indicators if – "p 1": refill indicators are activated you wish.
Before using for the first time Rinse aid Rinse aid helps to prevent spotting on dishes and glassware. The rinse aid is filled in the reservoir and the set amount will be automatically dosed. Filling the rinse aid reservoir with detergent (liquid or powder) will damage the reservoir.
Before using for the first time Rinse aid indicator When the Rinse aid indicator comes on, the reservoir only contains enough rinse aid for 2 - 3 wash programs. ^ Add rinse aid soon. If you consistently use a detergent that contains salt and rinse aid, you can deactivate the refill indicators if you wish (see Before using for the...
Before using for the first time ^ Press the K button to turn the Setting the rinse aid dosage dishwasher off. The rinse aid dosage can be set at ^ Hold down the Program button and levels between 0 and 6 ml. The factory setting is 3 ml of rinse aid.
Loading the dishwasher ^ The spray arms must not be blocked Do not wash items soiled with by items that are too tall or hang ash, sand, wax, grease or paint in through the baskets. Check the dishwasher. clearance by manually rotating the Ash and sand do not dissolve and spray arms.
Loading the dishwasher Items not recommended for Glassware: dishwashing – There are no standard guidelines for washing glassware, when in doubt – Cutlery with wooden handles wash by hand. – Wooden cutting boards – When purchasing new dishes, – Glued items such as old knives with glasses and cutlery, make sure they handles glued together around the are dishwasher safe.
Loading the dishwasher Upper basket Adjustable cup rack (depending on model) Always use the dishwasher with ^ Raise the rack to make room for tall the upper and lower basket in place. glasses. Glasses can also be leaned against the cup rack so they are more stable.
Page 24
Loading the dishwasher Adjusting the upper basket To adjust the upper basket downwards: ^ Pull up on the levers at the sides of In order to gain more space for taller items the upper basket can be adjusted the upper basket. on three levels with 2 cm between each ^ Adjust the basket to the desired level.
Loading the dishwasher Lower basket Heavily soiled items ^ Place larger and heavier items such as plates, serving platters, saucepans, bowls, etc. in the lower basket. It can also be used for glasses, cups, small plates and saucers. Dishwasher with cutlery tray ^ Place very large plates in the center of the lower basket.
Loading the dishwasher MultiComfort zone Foldable spikes (depending on the model) The rear section of the lower basket is used for cups, glasses, plates, pots The spikes at the front are used for and pans. plates, soup bowls, platters, desert bowls, and saucers.
Loading the dishwasher Cutlery tray (depending on model) Spoons with thick handles may have to be placed as knives and forks with their heads in the holders. ^ Arrange the cutlery as shown in the cutlery tray. For easier unloading cutlery should be grouped in zones, one for knives, one for forks, one for spoons, etc.
Loading the dishwasher Cutlery basket Cutlery insert for the cutlery basket (depending on model) Use the insert supplied for heavily soiled items of cutlery. The insert separates the items so that they can be reached better by the spray jets. The cutlery basket can be placed anywhere on the front rows of spikes in the lower basket.
...wash long-stemmed glassware ... a glassware rack for the lower basket. MieleCare Collection Miele branded cleaning and care products, including dishwasher salt, detergent and rinse aid, are available to order from your Miele dealer, Miele or the on-line Miele store www.mieleusa.com...
Keep children away from the dishwasher when the door is Dishwasher cleaning products are open. There could still be detergent available from MIele. residues in the dishwasher. Only add detergent just before starting the program and lock the door with the child safety lock (depending on model).
Adding detergent ^ Add detergent to the compartments and close the container flap. ^ Press the latch on the detergent ^ Use one tab or add powder or gel dispenser. The flap will spring open. detergent to compartment II and The flap is always open at the end of a close the flap.
Turning the dishwasher on Starting a program ^ Open the water supply if it is closed. ^ Close the door to start the program. ^ Open the door. Cancel a program only in the first ^ Make sure the spray arms can rotate few minutes.
Program guide When to use Program sequence Pre-rinse Main Interim Final Drying wash rinse rinse Pots & Pans For normally soiled pots & pans with dried on food, and heavily soiled dishware, use 120% detergent recommended. Normal Program for completely washing a full load of required normally soiled dishware with...
Time display Standby Before the program starts, the time A few minutes after the last button is display shows the runtime of the pressed or a few minutes after the end selected program in hours and minutes. of the program the dishwasher will The remaining time is displayed during switch to Standby mode to save the program.
At the end of a program The dishes will cool much faster if you open the door when the program has ^ Open the door slightly to check ended. whether the program has finished. Unload the lower basket first, then the The time display shows a 0.
Interrupting a program Changing a program A program will be interrupted as soon Do not change the program if the as the door is opened. detergent dispenser flap is already When the door is closed again, the open. program will continue from where it was interrupted.
Additional options Turbo The "Turbo" function can be used to reduce the program run-times, in programs in which the option is available. Energy consumption will increase to achieve optimum results. ^ Open the door. ^ Press the K button to turn the dishwasher on.
Additional options If you keep the , button pressed, the Delay start time will increase automatically to 24^. The start time of a program can be To start at 30 minutes again, press the delayed. The start time can be delayed , button twice.
Additional options ^ Press the Turbo button four times. Buzzer A buzzer sounds at the end of a The Turbo indicator light shows 4 short program and when a fault occurs. flashes in intervals. The buzzer at the end of a program The flashing in the time display shows sounds four times in intervals with a whether the program end buzzer is...
Additional options ^ Open the door. Optimize Standby ^ Press the K button to turn the A few minutes after the last button is pressed or a few minutes after the end dishwasher off. of the program the dishwasher will ^ Press and hold the Program button switch to Standby mode to save and simultaneously turn the...
Additional options Factory defaults The flashing in the time display shows whether a setting is different from the If you have changed any settings, you default setting. can reset them to the factory defaults. – "p 1": all values are set to the default ^ Open the door.
The circuit breaker has – Reset the circuit breaker tripped. (see data plate for the correct fuse rating). – If the circuit breaker trips again, contact Miele. Press the K button and select The dishwasher is not turned on. a program. The dishwasher The circuit breaker has –...
Frequently Asked Questions Faults in the water intake or water drain Problem Possible fault Solution The dishwasher The water supply – Open the water supply all the way. stops shortly after is closed. the program starts. The buzzer sounds. The Intake/Drain indicator light alternates between flashing and...
Frequently Asked Questions General problems with the dishwasher Problem Possible fault Solution Press the K button to come The indicator lights The indicator lights and and the time display the time display turn off out of Standby mode. are dark. Only the automatically to save indicator light K energy (Standby).
Frequently Asked Questions Sounds Problem Possible fault Solution There is a knocking The spray arm is hitting an Interrupt the program, noise in the wash item in the basket. rearrange items blocking cabinet the spray arms. There is a rattling Items are not secure in the Interrupt the program, and wash cabinet.
Frequently Asked Questions Poor cleaning results Problem Possible fault Solution The dishes are not The dishes were not loaded See "Loading the clean. correctly. dishwasher". The program was not Select a more intensive powerful enough. program (see "Program Guide"). Not enough detergent was Use more detergent, or dispensed.
Page 47
Frequently Asked Questions Problem Possible fault Solution Dishes are not dry, The rinse aid setting may be Increase the dosage, refill glasses and too low, or the rinse aid the reservoir or switch the cutlery are reservoir is empty. rinse aid product when spotted.
Page 48
Frequently Asked Questions Problem Possible fault Solution Glasses have a Detergent deposits. Change detergent right brown or blue away. discoloration; film cannot be wiped off. Glasses are dull and Glasses are not dishwasher There is no remedy. discolored; film safe. The surface is Only use dishwasher safe cannot be wiped off.
Miele products will not be recognized to input these into your machine by Miele. Our goal is to prevent controls via the indicator light marked unauthorized (and untrained) service PC. Miele will provide information when personnel from working on your Miele such possibilities become available.
Remove the cleaner promptly. The wash cabinet can be cleaned with a dishwasher cleaner such as "Dis To prevent damage to your appliance Cleaner" available from your Miele avoid the following: dealer or online at www.mieleusa.com. – cleaners containing soda, ammonia,...
Cleaning and Care Triple filter system The triple filter system in the base of the wash cabinet prevents food from being redeposited on dishes. It also protects the circulation pump from damage caused by foreign objects (e.g. broken glass, bones). During normal use, the filter system is self-cleaning.
Page 54
Cleaning and Care ^ Return the filter so it lies flat in the To clean the inside of the filter, the flap must be opened. base of the wash cabinet. ^ Push the clips together ^ Lock the filter by turning the handle and open the flap clockwise.
Cleaning and Care Cleaning the spray arms Sometimes particles of food get stuck in the spray arm jets. The spray arms should be inspected and cleaned every 4 - 6 months. ^ Turn off the dishwasher before cleaning. Removing the spray arms ^ Remove the cutlery tray (if present).
Cleaning and Care Cleaning the drain pump and non-return valve If the dishwasher is not completely drained at the end of a program, the drain pump or non-return valve may be blocked. ^ Turn off the dishwasher and pull the plug.
Installation Instructions Please refer to the Installation Diagram supplied with these instructions. To comply with IEC sound testing protocols, please contact Miele for additional instructions. Information is subject to change. Please refer to our website to obtain the most current product specification, technical & warranty information.
Technical Service Department: right side of the door. U 1-800-999-1360 V 1-800-565-6435 A damaged power cord must only be replaced with a genuine Miele cord by a Miele service technician. Specifications The dishwasher comes equipped with a GROUNDING INSTRUCTIONS 4 ft (1.2 m) power cord with a molded...
Page 59
Electrical connection Hardwired electrical connection Prior to making a hardwire It is possible to hardwire this appliance connection to the terminal, remove to an existing power cable. the power cord. Otherwise there will be a risk of electric shock from the CAUTION: Before servicing, attached plug.
Plumbing Connection to the water – Water pressure: Must be between 4.5 - 145 psi (0.3 - 10 bar). supply – If the water pressure if lower, a Installation, repairs and other "Water Intake" notification will be work by unqualified persons could shown.
– Drain hose extensions and adapters pipe that is less than 8" (20 cm) above can be ordered from Miele. the floor, the drain must be vented. The maximum drain hose length is...
Page 64
Alteration rights reserved / 4212 M.-Nr. 09 510 220 / 01 G5280/G5285 / INFORMATION IS SUBJECT TO CHANGE. PLEASE REFER TO OUR WEBSITE TO OBTAIN THE MOST CURRENT PRODUCT SPECIFICATIONS, TECHNICAL & WARRANTY INFORMATION.