1200 Series IP Video Storage System Table of Contents | en Table of Contents Safety Instructions Overview Warnings and Precautions Preparing for Setup Electrical Safety Precautions General Safety Precautions System Safety System Overview System Interface Control Panel Buttons Control Panel LEDs...
| Safety Instructions 1200 Series IP Video Storage System Safety Instructions Overview This chapter provides a quick setup checklist to get your chassis up and running. Following the steps in the order given should enable you to have your chassis setup and operational within a minimal amount of time.
1200 Series IP Video Storage System Safety Instructions | en – DVD-ROM laser: CAUTION - This server may have come equipped with a DVD-ROM drive. To prevent direct exposure to the laser beam and hazardous radiation exposure, do not open the enclosure or use the unit in any unconventional way.
FB-DIMM memory modules, and four hot-swap drive bays offer maximum storage capacity. For information on supported hardware, see the datasheet for the 1200 Series in the Bosch Online Product Catalog. For more detailed technical information on your device refer to http:// www.supermicro.com/support/manuals/index.cfm.
1200 Series IP Video Storage System System Interface | en System Interface There are several LEDs on the control panel as well as others on the drive carriers to keep you constantly informed of the overall status of the system as well as the activity and health of specific components.
Page 8
| System Interface 1200 Series IP Video Storage System explains what each LED indicates when illuminated and any corrective action you may need to take. HDD: Indicates IDE channel activity. SAS/SATA drive activity when flashing. NIC1: Indicates network activity on GLAN1 / 2 when flashing.
1200 Series IP Video Storage System Installation | en Installation The systems comes pre-installed and only hard drives may be exchanged onsite. In case of any other failure the entire system has to be exchanged (by advanced exhange). Bosch Sicherheitssysteme GmbH Installation Manual DOC | V1 | 2010.08...
| Chassis Setup and Maintenance 1200 Series IP Video Storage System Chassis Setup and Maintenance This chapter covers the steps required to install components and perform maintenance on the chassis. Most components of the 1200 Series do not require tools or screws to set them up.
1200 Series IP Video Storage System Chassis Setup and Maintenance | en Rotating the Hard Drive Cage In order to access and install components in the chassis interior, it is necessary to rotate the hard drive cage. This will provide sufficient room to install and configure the chassis components.
Page 12
| Chassis Setup and Maintenance 1200 Series IP Video Storage System Gently slide the hard drive carrier out of the hard drive cage. If a hard drive is already present, remove it by carefully pulling the sides of the hard drive carrier outward.
1200 Series IP Video Storage System Chassis Setup and Maintenance | en 10. If desired, each hard drive carrier may be secured to the exterior of the hard drive cage using optional screws. 11. Rotate the hard drive cage 90 degrees inward, returning it to the closed, operational position in the chassis.
| Appendix 1200 Series IP Video Storage System Appendix Motherboard layout JPUSB1:B/P USB WAKE UP KB/MOUSE JPI2C:PWR I2C 1-2:ENABLE 2-3:DISABLE FLOPPY JPW1 JPUSB1 JTPM JI2C1 JI2C2 SLOT7 PCI-E X8 GEN2 JI2C1/JI2C2 ON:Enable OFF:Disable SLOT6 PCI-E X8 GEN2 SLOT5 PCI-E X4 on X8...
Page 15
1200 Series IP Video Storage System Appendix | en X8SIL/X8SIL-F/X8SIL-V Jumpers Number Jumper Description Default JPUSB1 BP USB0/1 Wake-up Pins 1-2 (Enabled) JBT1 CMOS Clear JPES Energy Saving Feature Pins 2-3 (Disabled) 13,14 JI2C1/JI2C2 SMB to PCI Slots JPG1 Onboard VGA Enable...
Page 16
| Appendix 1200 Series IP Video Storage System Floppy Floppy Disk Drive connector Alarm Reset Speaker header (Pins 3/4: Internal, 1~4:External) Front Panel Control header Chassis Intrusion header JLED Power LED Indicator header JPW1 24-pin ATX main power connector (required)
Page 17
1200 Series IP Video Storage System Appendix | en Network Connections Two Intel 82574L Gigabit (10/100/1000 Mb/s) Ethernet Controllers for LAN 1 and LAN 2 ports. Two (2) RJ-45 Rear IO Panel Connectors with Link and Activity LEDs Single Realtek RTL8201N PHY to support IPMI 2.0 (X8SIL-F...
| Appendix 1200 Series IP Video Storage System CPU/System overheat LED and control CPU Thermal Trip support Thermal Monitor 2 (TM2) support Fan Control Fan status monitoring with firmware 4-pin (Pulse Width Modulation) fan speed control Low noise fan speed control System Management PECI (Platform Environment Configuration Interface) 2.0...
1200 Series IP Video Storage System Appendix | en Note: This is a general block diagram and may not exactly represent the features on your motherboard. See the Motherboard Features pages for the actual specifications of each motherboard. Chipset Overview The X8SIL/X8SIL-F/X8SIL-V supports the Intel Xeon 3400 processor series.
| Appendix 1200 Series IP Video Storage System pre-defined overheat threshold, the CPU thermal trip feature will be activated and it will send a signal to the buzzer and, at the same time, the CPU speed will be decreased.
1200 Series IP Video Storage System Appendix | en drives. The Super I/O supports two 360 K, 720 K, 1.2 M, 1.44 M or 2.88 M disk drives and data transfer rates of 250 Kb/s, 500 Kb/s or 1 Mb/s.
Page 22
| Appendix 1200 Series IP Video Storage System DOC | V1 | 2010.08 Installation Manual Bosch Sicherheitssysteme GmbH...