Related Manuals for Miele DA 265-2
Summary of Contents for Miele DA 265-2
- Page 1 Operating and Installation Instructions Cooker hood DA 265-2 It is essential to read these operating instructions before installing or using the machine to avoid the risk of accidents or damage to the machine. M.-Nr. 05 609 530...
-
Page 2: Table Of Contents
Contents Contents Caring for the environment ......... . 3 Warning and Safety Instructions . -
Page 3: Caring For The Environment
Caring for the environment Caring for the environment Disposal of packing material Disposal of your old appliance The transport and protective packing Old appliances may contain material has been selected from materials which can be reclaimed or recycled. which are environmentally friendly for Please contact your dealer, your local disposal and can normally be recycled. -
Page 4: Warning And Safety Instructions
Warning and Safety Instructions Warning and Safety Instructions It is most important that this basic This appliance conforms to statu- safety requirement is tested by a quali- tory safety requirements. Incorrect fied electrician. use can lead to injury and damage The manufacturer cannot be held re- to the appliance. - Page 5 These can be obtained from the otherwise condensation may collect in Miele Spare Parts department or from the hood, which could cause corrosion. builders’ merchants. When cooking with oil or fat, chip...
- Page 6 Warning and Safety Instructions Disposal of your old appliance When using the cooker hood at the same time as another heating ap- Before discarding an old ap- pliance which depends on the air in the pliance switch off and disconnect room, (e.g.
-
Page 7: Functional Description
Functional description Functional description The cooker hood works with . . . Air extraction The air is drawn in and cleaned by the grease filters and directed outside. The cooker hood is fitted with a non-return flap This flap is closed when the cooker hood is switched off. -
Page 8: Guide To The Appliance
Guide to the appliance Guide to the appliance... - Page 9 Guide to the appliance Exhaust socket: Automatic touch control This control selects and de-selects Canopy "Automatic" operation in which drawing the canopy down or pushing it back up Shelf alters the fan power level. Grease filters Grease filter touch control The indicator lamp for the grease filter Touch control for hob touch control lights up when the grease...
-
Page 10: Operation
Operation Operation Switching on Selecting the power level When the canopy is pushed right up Depending on how much the air needs (retracted), the cooker hood is to be filtered, there are four power switched off and cannot be operated. levels available. -
Page 11: Run-On Option
Operation Switching off With automatic operation the power set- ting can also be altered manually. You can switch the fan off by either Use the power level control to select repeatedly pressing the left hand the setting required. control until all the indicator lamps Whatever the position of the canopy go out, the fan will switch to the power setting... -
Page 12: Filter Operating Hours Counter
Operation Filter operating hours counter Reading the filter operating hours counter The number of hours the appliance has been in operation is stored in memory. To check the percentage of time set al- ready used: Switch the fan on. The indicator lamp for the grease filter control will light up after 30 hours of operation. -
Page 13: Altering The Filter Operating Hours Counter
Operation Altering the filter operating hours counter The operating hours counter for the Press the run-on option touch control grease filters is set at 30 hours. This and the grease filter touch control at can be lengthened or shortened to suit the same time. -
Page 14: Power Cut
Operation Power cut If there is a power cut while the canopy is pulled down, the Automatic function is cancelled. Restore as follows: Push the canopy right back in (until a resistance is felt). Draw the canopy back down again until the desired power level position is reached. -
Page 15: Cleaning And Care
E-Cloth countries where this is applicable. A microfibre "E-Cloth" is available from Extension leads do not guarantee the Miele UK Spare Parts Department, the required safety of the appliance Part Number 98013530, which is suit- (e.g. danger of overheating). able for cleaning surfaces such as... -
Page 16: Setting The Shock Absorber
Cleaning and care After replacing the grease filters, press the grease filter touch control for approx. 4 seconds to re-set the operating hours counter. Setting the shock absorber: If after a period of protracted use it becomes necessary to adjust the shock absorber of the adjustable canopy, proceed as follows: To remove the upper grease filter... -
Page 17: Changing The Compact Light Unit
Cleaning and care Changing the compact light unit Before any cleaning or maintenance work the cooker hood must be dis- connected from the mains. Ensure current is not supplied to the ap- pliance while maintenance work is being carried out. The appliance is only completely isolated from the electricity supply when:... -
Page 18: After Sales Service
After Sales Service In the event of a fault which you cannot correct yourself please contact: – Your Miele Dealer – The Miele Service Department (see back cover for address). When contacting the Service Depart- ment, please quote the model and serial number of your appliance. -
Page 19: Electrical Connection
Electrical connection Electrical connection For extra safety it is advisable to install All electrical work should be under- a residual current device (RCD) with a taken by a suitably qualified and trip current of 30 mA (in accordance competent person in strict accord- with DIN VDE 0664, VDE 0100 Section ance with national and local safety 739). - Page 20 Electrical connection Important UK Important If the appliance is fitted with a non-re- The wires in the mains lead are col- wireable plug (BS 1363 UK) and the oured in accordance with the following socket outlets are not suitable for the code: plug supplied, or if the existing plug Green/yellow = earth...
-
Page 21: Installation
Installation Installation The cooker can only be installed above an electric hob. Safety regulations prohibit the fitting of this cooker hood over a gas hob, an open grill (electric) or a solid fuel stove. The distance between the top of the hob and the bottom of the cooker hood (when the canopy is com- pletely retracted) must measure at... -
Page 22: Building In
Installation Building in Take the door off the wall unit for ea- sier installation. Push the cooker hood into the wall unit from the front and hang on the support tracks. Fix the support tracks on each interior The cooker hood must only be lifted side wall of the unit, using four 3.5 x by the main body, and not by the 16 mm screws for each track. - Page 23 Installation 19 mm thick unit sides: Use 3.5 x 16 mm screws to secure the cooker hood to the wall unit on both sides at the lower edge of the 16 mm thick unit sides: body. Using the 3.5 x 16 mm screws se- cure the cooker hood to the wall unit on either side as shown.
-
Page 24: Depth Alignment
Installation Depth alignment Units deeper than 285 mm require the fitting of a spacer bar to prevent va- pours collecting between the rear of the cooker hood and the wall. Press the facia strips into their Adjust the spacer bar to the appro- holders according to the thickness of priate depth along the required the side walls. -
Page 25: Fitting The Shelf
Installation Preparation for extraction Fit each grease filter with the hand hold to the rear. For exhaust connection, push the Fit the door back on to the wall unit. ducting on to the exhaust socket of the cooker hood Fitting the shelf Complete venting installation. -
Page 26: Connection For Air Extraction
Connection for air extraction Connection for air extraction – Where ducting is horizontal it must Danger of toxic fumes. be laid to slope away at at least 1 Please heed the "Warning and cm per metre. Safety instructions" to avoid the danger of toxic fumes. -
Page 27: Condensate Trap
Connection for air extraction Important: If the exhaust ducting is to run through rooms, ceiling space etc. where there may be great variations in temperature between the different areas, the prob- lem of sweating or condensation will need to be addressed. The exhaust ducting will need to be suitably insu- lated. -
Page 28: Technical Data
Technical data Technical data Technical data Rated load ....212 W Motor ..... 190 W Lighting . - Page 32 Alteration rights reserved / 44 / 000 GB / ZA - 1301 This paper consists of cellulose which has been bleached without the use of chlorine.