Related Manuals for Miele T 1570CI CONDENSER DRYER
Summary of Contents for Miele T 1570CI CONDENSER DRYER
- Page 1 Operating Instructions Condenser Dryer T 1570 C To prevent accidents and machine damage read these instructions before installation or use. M.-Nr. 03 719 550...
-
Page 2: Table Of Contents
INSTALLATION INSTRUCTIONS ........23... -
Page 3: Important Safety Instructions
Keep the area around the air intake They give off vapors that could ignite or (toekick) and adjacent surrounding explode. areas free from lint, dust and dirt. Do not allow children to play on or The interior of the machine and in the appliance. -
Page 4: Save These Instructions
IMPORTANT SAFETY INSTRUCTIONS Do not repair or replace any part of WARNING – Improper connection the appliance or attempt any of the equipment grounding servicing unless specifically conductor can result in a risk of electric recommended in these Operating shock. Check with a qualified Instructions. -
Page 5: Guide To The Dryer
Guide to the dryer 1 Supply cable with plug 2 Control panel 3 Drum door 4 Exhaust connection (right, left or rear) 5 Four height-adjustable legs... - Page 6 Guide to the dryer Push buttons Indicators – Door – Empty out container Opens the door or can be used to The condensed water container cancel a program (does not stay should be emptied. pushed in). – PROGRAM SEQUENCE – ON / OFF...
-
Page 7: Before Loading The Dryer
Close zippers and tie up fabric belts and apron ties. If no symbol is present: Do not dry items that may melt or ignite Dry cottons and permanent press in the dryer such as plastics, rubber or laundry in their corresponding sneakers. -
Page 8: Using The Dryer
^ Press the "Door" button to open the door. ^ Load the laundry loosely into the drum. ^ Close the door with a firm swing - do not push it shut. Do not use fabric softener sheets in this dryer. Silicates contained in these sheets could cause the dryer to overheat. -
Page 9: Select A Program
Please refer to the "Programs" chart. The program status will be stored for 30 minutes in the event of a power failure. ^ Press the "Low temp." button to reduce the temperature when drying... -
Page 10: Programs
If fabrics are too damp for ironing, redry using "Hand iron r". Machine iron Cotton or linen fabrics, which To prevent moisture loss, roll up will be ironed with a rotary iron. the laundry until ironing. PERMANENT PRESS Normal+ Permanent press items. Normal... -
Page 11: Using The Dryer
The "Anti-crease/Finish" indicator will light at the end of a program. ^ Turn the program selector to "Finish". ^ Press the "START" button. ^ Press the "Door" button to open the door. ^ Remove the laundry. ^ Check that the drum is empty. -
Page 12: Dryer Care
^ Open the door and remove the lint ^ Stainless steel surfaces can be filter. cleaned using a non-abrasive ^ Wipe the lint off the filter with your stainless steel cleaner. hand, do not use any sharp objects! ^ Wipe dry using a soft cloth. -
Page 13: Emptying The Condensed Water Container
To empty the container container Depending on your type of installation, the condensed water will either be pumped to a drain, or collected in the condensed water container, located in the upper left corner of the machine. The container holds approximately 1 gallon of water. -
Page 14: Cleaning The Heat Exchanger
^ The heat exchanger should be cleaned every 6 months. ^ Open the door. ^ Remove the cover. ^ Turn the lever so that it is vertical. ^ Turn both levers, on the heat exchanger, so that they are vertical. - Page 15 ^ Replace the heat exchanger in the reverse order. ^ Make certain the heat exchanger is pushed in all the way and that the cover is firmly closed. Otherwise water may leak from the machine. – at both ends (front and back)
-
Page 16: Changing The Light Bulb
To reduce the risk of electric shock, disconnect this appliance from the power supply by unplugging or tripping the circuit breaker. ^ Pull forward on the unhinged side of the door. ^ Unscrew the plastic bulb cover located inside the drum and above the door (see illustration.) -
Page 17: Quick Guide
Quick Guide Remove this guide for easy reference Please read all instructions, especially the "Important Safety Instructions", before using the dryer. - Page 18 To prevent fabric damage, check that laundry will not be caught in the ^ Press the "Buzzer" button. closed door. ^ Close the door with a firm swing - do not push it shut.
- Page 19 ^ Press the "Low temp." button to reduce the temperature when drying delicate fabrics. ^ Press "Door" and remove the laundry. 5. Start the program ^ Press "START". ^ Clean the lint filter. ^ Press the "On/Off" button to turn off the dryer.
- Page 20 If fabrics are too damp for ironing, redry using "Hand iron r". Machine iron Cotton or linen fabrics, which To prevent moisture loss, roll up will be ironed with a rotary iron. the laundry until ironing. PERMANENT PRESS Normal+ Permanent press items. Normal...
-
Page 21: Frequently Asked Questions
Frequently asked questions With the following guide, minor problems can be fixed without a service call. What if Possible fault . . . the tumble Check whether the "On" Repeat the program selection dryer fails to start indicator lights up. If so,... - Page 22 If the indicator lamp starts flashing again, this indicates a fault in the machine. Please contact the Miele Service Dept..the drum door opens The machine has Before restarting the during the drying cycle? overheated. The program, proceed as...
- Page 23 Frequently asked questions What to do if, . . . ? Cause . . . Remedy ..drops of water This may not be a These two seals may appear along the upper problem. A dual filter...
-
Page 24: After Sales Service
After Sales service In the event of a problem which you cannot fix yourself, or to order spare parts please contact: – Your Miele Dealer – The Miele Technical Service Department 1-800-999-1360 techserv@mieleusa.com 1-800-565-6435 service@miele.ca When contacting the Technical Service Department, please quote the model and serial number of your appliance. -
Page 25: Installation Instructions
Installation Instructions To prevent accidents and machine damage read these instructions before installation or use. -
Page 26: Important Safety Instructions
WARNING – Improper connection of the equipment-grounding conductor can result in a risk of electric shock. Check with a qualified electrician or service representative or personnel if you are in doubt as to whether the appliance is properly grounded. -
Page 27: Installation Instructions
Before discarding an old plastic wrappings, bags etc. are appliance, unplug it from the outlet and disposed of safely and kept out of the cut off its power cord and remove any reach of children. doors to prevent hazards. -
Page 28: Installation
The tumble dryer can also be placed on top of a Miele washing machine for a stacked installation. An appropriate stacking kit is required. The stacking kit, part # 12 996 026, is... -
Page 29: Changing The Decor Panel
Note: The door should be closed can be concealed using a toekick when installing the decor panel. panel. ^ On the door lock side remove the The height and depth of the appliance 4 screws (3 on the side and 1 toekick cannot be altered. -
Page 30: Connecting To An External Drain
Installation Connecting to an external drain The condensed water can be sent directly to a drain if the machine is installed near a sink or standpipe. The machine is equipped with a non- return valve that will prevent water from flowing back into the machine if there is a problem in the drainage system. - Page 31 ^ Attach the elbow to the hose and secure it to the sink or into the drain pipe. If room is available, it can be inserted into the stand pipe used by the washing machine.
-
Page 32: Make The Electrical Connection
Installation Make the electrical connection Electrical connection The dryer comes with a 5 ft long, 12/4 GROUNDING INSTRUCTIONS AWG cord and a NEMA 14-30 P plug. This appliance must be grounded. In the event of malfunction or It should be connected to a... - Page 36 All rights reserved / 4503 M.-Nr. 03 719 550 / 04 For the most updated manual check the Miele website.