hit counter code

Connecting The Electrobrush; General Battery Information - Miele Triflex HX2 Operating Instructions Manual

Cordless vacuum cleaner
Hide thumbs Also See for Triflex HX2:
Table of Contents

Advertisement

Connecting the Electrobrush

Depending on how you decide to con-
figure your vacuum cleaner, you can
connect either the PowerUnit connector
or the suction tube connector to the
Electrobrush.
 Push the connector into the Electro-
brush from above until it audibly clicks
into place.
 To separate the individual sections
from each other, press the release
catch on the Electrobrush and pull the
connector out of the Electrobrush.
Installation and connection

General battery information

The rechargeable battery is supplied not
fully charged.
Charge the battery completely before
using it for the first time. Allow approx-
imately 4 hours for this.
To activate the battery, it is essential to
place it in the PowerUnit when charging
it for the first time.
Once the battery is fully charged, the
battery charging state indicator on the
PowerUnit switches off to conserve en-
ergy.
The maximum charging capacity is
only achieved once the battery has
been charged and run down five times.
A full charge provides enough power for
14 minutes if the vacuum cleaner is
used at the maximum power level in its
fully assembled state.
However, if you use the PowerUnit solo
and select the minimum power level,
you can vacuum for up to 60 minutes at
a time.
19

Advertisement

Table of Contents
loading

This manual is also suitable for:

Triflex hx2 proTriflex hx2 racerTriflex hx2 performanceTriflex hx2 cat & dogTriflex hx1 facelift

Table of Contents