“Connection” chapter as well as the safety instructions and warnings. Miele cannot be held liable for injury or damage caused by non-compliance with these instructions. Keep these operating instructions in a safe place and pass them on to any future owner.
Page 4
en - Warning and Safety instructions This vacuum cleaner is not intended for outdoor use. This vacuum cleaner is intended for use at altitudes of up to 4000 m above sea level. The vacuum cleaner must only be used to vacuum dry floor surfaces.
Page 5
Reliable and safe operation of this vacuum cleaner can only be assured if it has been connected to the mains elec- tricity supply. While the vacuum cleaner is under warranty, repairs should only be undertaken by a Miele authorised service technician. Otherwise the warranty will be invalidated.
Page 6
Do not use the vacuum cleaner if the cable is damaged. If the cable is damaged it must be replaced together with a complete cable rewind. For safety reasons this must only be done by Miele Service or a Miele authorised service technician. ...
Page 7
- Warning and Safety instructions Miele can only guarantee the safety of the appliance when genuine Miele replacement parts are used. Faulty components must only be replaced with genuine Miele re- placement parts. Correct use To avoid the risk of damage, do not use the vacuum cleaner without the dustbag, dust compartment filter and exhaust filter in place.
Page 8
- Warning and Safety instructions Accessories To avoid the risk of injury when vacuuming with a Miele Turbobrush, do not touch the rotating roller brush. It is not advisable to vacuum directly with the handle, i.e. without an accessory attached as the rim could get dam- aged and you could hurt yourself on sharp edges.
Page 10
Carrying handle i Original Miele dustbag j Motor protection filter k Park system for storage (on both sides of the vacuum cleaner) l Original Miele exhaust filter* m Connection cable n Footswitch for automatic cable rewind o Suction power selector p Park system for pauses during vacuuming q On/Off footswitch ...
/ recycling centre for electrical and electronic ap- pliances, or contact your dealer or Miele for advice. You are also respons- ible (by law, depending on country) for deleting any personal data that may be stored on the appliance being disposed of.
These operating instructions and addi- class on carpet and hard floors and tional information are available to down- sound power level on carpet the ad- load from the Miele website at justable floorhead was used with the www.miele.com. brush retracted (press the foot- switch).
Connecting the telescopic tube to Illustrations the floorhead (dia. 05) The illustrations referred to in the text Push the telescopic tube into the are shown on the fold-out pages at floorhead and turn it clockwise or the end of these operating instruc- anti-clockwise until it clicks into posi- tions.
For cleaning in folds, crevices or bust hard flooring. corners. Miele offers a range of other floorheads, Accessories holder for the brushes and accessories for other types above accessories (dia. 13) of flooring and special applications (see Symbols on the holder show “Optional accessories”).
Page 15
Step briefly on the cable rewind foot- Clean hard flooring which is not sus- ceptible to scratching, as well as floor- switch. ing with gaps or deep crevices in it with The cable will then retract itself fully into the brush protruding: the vacuum cleaner.
Turn the suction power selector Setting down, transportation manually to the power level you re- and storage quire. Park System for pauses during To open the air inlet valve (dia. 23) vacuuming (dia. 25) It is easy to reduce the suction power The Park System allows you to conveni- for a short time, e.g.
Purchasing dustbags and filters Maintenance Original Miele dustbags and filters are Always disconnect the vacuum available from the Miele webshop, the cleaner from the electrical supply for Miele Spare Parts Department and your maintenance work and for cleaning. Miele dealer.
Remove the dustbag (dia. 29) Miele dustbags are intended to be used only once. Dispose of the dust- Press the release catches at the side bag when it is full. Do not attempt to of the hose connector, and lift the re-use.
Silence AirClean 50, Active AirClean Replace this filter every time you start a 50 or HEPA AirClean 50 filter, see the new packet of Miele dustbags. Every “Replacing one type of exhaust filter packet of original Miele dustbags con- with another” section.
Replacement parts are available from that you remove the filter grille before your Miele dealer or from the Miele you fit the new exhaust filter. Spare Parts Dept.
Cleaning and care Always disconnect the vacuum cleaner from the electrical supply be- fore cleaning it. Switch off at the wall socket and unplug it. Vacuum cleaner and accessories The vacuum cleaner and all plastic ac- cessories can be cleaned with a propri- etary cleaner suitable for plastic.
Problem solving guide Many malfunctions and faults that can occur in daily operation can be easily remedied. Time and money will be saved because a service call will not be needed. The following guide may help you to find the reason for a malfunction or a fault, and to correct it.
These and many other products can be cannot remedy yourself, please contact ordered from the Miele webshop, the your Miele Dealer or Miele Service. Miele Spare Parts Dept. or your Miele Contact information for Miele Service dealer. can be found at the end of this docu- Floorheads / brushes ment.
Page 24
Other accessories Filters MicroSet (SMC 20) AirClean Plus 50 exhaust filter (SF-AP 50) This set is specially designed for clean- ing small objects and difficult to reach Effective filtration for particularly clean room air. areas (such as PC keyboards, stereo equipment, intricately carved furniture Exhaust filter Silence AirClean 50 and ornaments, models etc).
Electrical connection for Electrical connection AU, the UK All electrical work should be carried out All work should be carried out by a suit- by a suitably qualified and competent ably qualified and competent person in person in strict accordance with current strict accordance with national and national and local safety regulations (BS local safety regulations.