5019_719_01132_GB 1-06-2007 14:30 Pagina 3 Product description and symbols Using the burners Practical advice on using the hob Positioning the pan supports and wok support Hood and cabinetry clearances (mm) Injector table Warnings and suggestions Safeguarding the environment Installation (Flush and Traditional fitting) Gas connection Electrical connection Fixing the Hob to the supporting structure.
5019_719_01132_GB 1-06-2007 14:30 Pagina 5 Practical advice on using the hob Read the instructions to get the best out of your You should never use: hob. • two burners simultaneously with just one • Use pans with a similar diameter to the container such as a fish kettle.
5019_719_01132_GB 1-06-2007 14:30 Pagina 6 Hood and cabinetry clearances (mm) If a hood is to be installed above the hob, refer to the hood installation instructions to ensure the correct height above the hob. Note: If the distance “A” between the kitchen wall cabinets is between 600 and 730 mm, height “B"...
5019_719_01132_GB 1-06-2007 14:30 Pagina 7 Warnings and suggestions To get the most out of your hob, please read Note: the instructions carefully and keep them for • Incorrect placement of the pan supports can future consultation. scratch the hob. To avoid this always ensure •...
5019_719_01132_GB 1-06-2007 14:30 Pagina 8 Safeguarding the environment Packing Note: The packing material is 100% recyclable and is • Incorrect placement of the pan supports can labelled with the recycling symbol . Please scratch the hob. To avoid this always ensure dispose of all packing responsibly and carefully.
- created in such a way that the openings both • This hob is designed to operate perfectly with inside and out cannot be obstructed, even in any oven in the KitchenAid range. The error. Manufacturer declines all responsibility should - Protected by plastic grill, metallic netting etc.
5019_719_01132_GB 1-06-2007 14:30 Pagina 10 Electrical connection The electrical connections must comply with current legislation and be carried out by a qualified, competent person. • Information on the voltage and power absorbed are shown on the serial no. plate. Earth •...
5019_719_01132_GB 1-06-2007 14:30 Pagina 11 Fixing the Hob to the worktop. Flush fitted model. Important: The following procedure shall be carried out by competent technical personnel only. The hob can be installed on different types of materials, such as masonry, metal, bare wood and heat resistant laminate coated wood (90°C).
5019_719_01132_GB 1-06-2007 14:30 Pagina 12 Adaption to a different type of gas supply If you are using a different kind of gas from the one requested from the Customer Care Centre on indicated on the serial no. plate and the orange 00800-3810-4026.
5019_719_01132_GB 1-06-2007 14:30 Pagina 13 Fitting the wok burner To fit the double crown wok burner: Insert in the following order: 1. burner ring (A); 2. decorative covering ring (B); 3. external burner cap (C); 4. internal burner cap (D). Note: make sure that: 1.
5019_719_01132_GB 1-06-2007 14:30 Pagina 14 General cleaning & maintenance Always disconnect the hob from the electrical • Do not leave acidic or alkaline based products power supply and wait until it cools before cleaning like vinegar, mustard, salt, sugar or lemon juice and/or doing maintenance work.
5019_719_01132_GB 1-06-2007 14:30 Pagina 15 Troubleshooting guide If the hob is not working properly, work through 3. the end part of the thermocouple is clean. this guide before contacting our Customer Care Centre. The pans are not stable? Check that: 1.
Page 16
5019_719_01132_GB 1-06-2007 14:30 Pagina 16 Whirlpool Europe S.r.l. Viale G. Borghi, 27 - 21025 Comerio (VA) Phone 0332.759111 - Fax 0332.759268 www.whirlpool.eu Printed in Italy 06/07 5019 719 01132...