Counter-rotating groomer drive system dpa cutting units for greensmaster flex 1800/2100, eflex 1800/2100, andtriflex 3300/3400 series traction unit (16 pages)
Table of Contents Page OPERATING INSTRUCTIONS SPECIFICATIONS Cutting Unit Daily Adjustments ADJUSTING CUTTING UNIT LUBRICATION Adjusting The bedknife To The Reel Greasing Bearings And Bushings Leveling Front Roller To The Reel BACKLAPPING THE CUTTING UNITS Adjusting Height-of-Cut Specifications Height-of-Cut: The cutting height is adjusted on rear for each indexed position.
Adjusting the Cutting Units do so may result in damage to the cutting unit. Note: Left and right sides of the cutting unit refer to normal operating position. After the cutting unit is unboxed, use the following procedures to assure the cutting units are adjusted properly.
Adjusting Cutting Units Position a 6 mm or thicker plate under the reel typically used. blades and against the front face of the bedknife. The upper position is more aggressive and may be Note: Be sure the plate covers the full length of used in a limited height-of-cut range (.140-.250") if the reel blades and three blades contact the plate.
Adjusting the Cutting Units IMPORTANT: Repeat the procedure on each end Note: As the reel blades continue to run against the of the bedknife and tighten locknuts that retain bedknife, a slight burr will appear on the front cutting rear roller brackets on each end. edge surface the full length of the bedknife.
Apply grease until pressure is felt against the handle. IMPORTANT: Do not apply too much pres- Backlapping the Cutting Units lapping are available in the TORO Sharpening Reel & CAUTION Rotary Mowers Manual Form No. 80-300PT. Be careful when lapping the reel because contact...
Page 7
? @ e 7 @ ( Y e W & @ ) X ? e W & @ @ @ U e V ' @ 1 e @ ? Where a warrantable condition exists, Toro will repair the Product at no cost to you including diagnosis, ? @ e @ @ H ? ? W .