Advertisement
Quick Links
Accessory Wiring Kit
Groundsmaster
Model No. 115-8492
Installation
For Models 30412 and 30413
1. Position the machine on a level surface, lower the
cutting unit, stop the engine, engage the parking
brake and remove the key from the ignition.
2. Disconnect the negative battery cable from the
battery.
3. Remove the control panel cover (Figure 1) to gain
access to the fuse block area.
1
Figure 1
1. Control panel cover
4. Locate the holes under the decal on the top of the
control console. Remove the decal material covering
the holes (Figure 2).
5. Clean the mounting surface and apply the control
decal over the holes on the control console (Figure 2).
6. Loosely mount a toggle switch in each hole with the
washers and nuts supplied (Figure 2).
© 2010—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
4000-D and 4100-D Series Traction Unit
1. Console decal
2. Toggle switches
7. Plug the (2) connectors from the accessory wire
harness onto the toggle switch terminals (Figure 2).
8. Remove the (3) screws and nuts securing the fuse
block to the inside of the control console (Figure 3).
9. Move the fuse block down to the next set of
mounting holes and reinstall with the screws and
nuts previously removed (Figure 3).
G009954
1. Fuse block
Register at www.Toro.com.
Form No. 3365-152 Rev A
Installation Instructions
2
3
G009955
Figure 2
3. Harness connectors
2
G009956
Figure 3
2. Grounding bolt
1
1
Original Instructions (EN)
Printed in the USA.
All Rights Reserved
Advertisement
Related Manuals for Toro 115-8492
Summary of Contents for Toro 115-8492
- Page 1 Form No. 3365-152 Rev A Accessory Wiring Kit Groundsmaster ® 4000-D and 4100-D Series Traction Unit Model No. 115-8492 Installation Instructions Installation For Models 30412 and 30413 1. Position the machine on a level surface, lower the cutting unit, stop the engine, engage the parking brake and remove the key from the ignition.
- Page 2 10. Secure the ground wires (ring terminals) from the decal surface is clean and dry before affixing the accessory and power harness’ to the grounding bolt decals. located beneath the fuse blocks (Figure 2). Important: When routing the harness, do not pull it across sharp edges which may damage the wires.
- Page 3 G009960 Figure 7 Figure 8 1. Mounting pads 1. Hydraulic line cover 2. Steering tower cover 22. Insert a cable tie through each of the plastic 5. From inside the steering tower, press the plug out of mounting pads. the hole in the top of the tower (Figure 9). 23.
- Page 4 10. Open the hood and route the power and ground connector end of the harness back along the right side of the machine to the power center (Figure 10). g011539 Figure 10 1. Power center Figure 12 11. Open the cover on power center to expose the fuse blocks (Figure 11).