Page 1
Installation Precautions Mounting angle adjustment •Do not tamper with the four holes on the upper surface of the unit. They are for tuner adjustments to be made only by service technicians. Adjust the mounting angle to less than 60°. •Choose the installation location carefully so that the unit will not interfere with the driver wile driving. •Avoid installing the unit where it would be subject to high temperatures, such as from direct sunlight or hot air from the heater, or where it would be subject to dust, dirt or excessive vibration.
Connection diagram Connections Set the LINE-OUT/IN SELECT switch to position 2 Caution EQ OUT •This unit is designed for negative ground 12 V DC operation only. •Before making connections, disconnect the ground terminal of the car battery to avoid short circuits. •Connect the yellow and red power input leads only after all other leads have been connected.
Connection example RCA pin cord (not supplied) RCA pin cord (not supplied) EQ OUT BUS cable (not supplied) When connecting digital pre-amplifier RCA pin cord (not supplied) LINE OUT/IN REAR Digital pre-amplifier XDP-U50D LINE OUT/IN FRONT Inverter Note BUS CONTROL IN Never bundle the inverter’s cords with any others.