Operating instructions Vacuum cleaner S 5981 en - US, CA To prevent accidents and appliance damage, read these instructions before installation and use. M.-Nr. 09 096 100...
Connecting the vacuum cleaner to a higher voltage than indicated in these instructions may result in damage to the vacuum cleaner or injury. To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other.) This...
Page 5
Do not use on people or animals. Do not use outdoors or on wet surfaces. Only dry surfaces should be vacuumed. Use only as described in this manual. Use only Miele recommended accessories. Do not alter or modify the vacuum cleaner. This appliance is intended for household use only.
Hose, Telescopic wand, Turbobrush and Powerbrush. To avoid the risk of injury when vacuuming with a Miele Power or Turbobrush do not touch the rotating roller brush. Danger of injury. The socket on the vacuum cleaner (depending on model) must only be used for the Miele Powerbrush specified for use with this appliance.
Page 7
If the power cord is damaged it should be replaced along with a new cable reel by Miele Technical Service. Disposing of an old appliance Before discarding an old vacuum cleaner, please cut off the power cord and render the plug useless.
Guide to the vacuum cleaner Hand piece Suction power buttons + / – On/Off button for Powerbrush with LED Standby button with LED for vacuum pauses Power level display Lock release button Electro Telescopic wand Electro Telescopic wand release button...
Before using the vacuum cleaner Connecting the Electro hose ^ Insert the elbow into the suction socket until it clicks. Use the inlet guides to direct insertion. Disconnecting the Electro hose ^ Press the release buttons at the sides of the elbow and lift the hose from the...
Page 11
^ Press the telescopic wand release button (see arrow) to release the tubes and adjust to the desired height. Before using the vacuum cleaner...
The Powerbrush can also be used on smooth floor surfaces. The standard floor brush or the Miele parquet floorbrush should be used to clean delicate hard flooring and floor surfaces susceptible to scratching.
Page 13
The floor brush is suitable for cleaning carpets, rugs, and hard surfaces. For flooring susceptible to scratching, use one of the special Miele floor brushes (see "Optional accessories"). Connecting the Electro Telescopic wand to a floor tool ^ Fit the Electro Telescopic wand firmly into the floor tool.
Included accessories The following accessories are included: Crevice nozzle Dust brush with natural bristles Upholstery tool Taking the accessories out ^ Press the releasing lock (see arrow). The accessory compartment opens. ^ Take out the accessory needed. ^ Close the lid securely.
Page 15
Included accessories Crevice tool For cleaning in folds, crevices and corners. Dust brush with natural bristles For cleaning moldings, ornate or carved articles, etc. The head of the dusting brush swivels and can be turned to attain the best cleaning position.
Page 16
Included accessories Upholstery tool For cleaning upholstery, mattresses, cushions, curtains, covers, etc. Standard floor brush (depending on model) The standard floor brush can be used for normal cleaning of carpets, rugs, hard surfaces, carpeted stairs, etc. For safety, when vacuuming stairs it is best to start at the bottom and move upwards.
Power cord Unwind the cord completely to aid the vacuum in dissipating heat. Do not pull or carry by the cord, use the cord as a handle, close a door on the cord, or pull the cord around sharp edges or corners. Do not run the appliance over the cord.
^ Press – to select a lower power level. ^ Press + to select a higher power level. To pause the vacuum cleaner during operation: ^ Press the Stand-by button. The LED on the handle will light up.
Adjusting the suction Use the + and - on the handpiece to adjust the suction to suit the type of flooring. By reducing the suction power the floor brush can be pushed easier. The symbols on the controls indicate the type of use the settings are suitable for.
While vacuuming The vacuum cleaner can also stand on its end for vacuuming stairs, drapes etc. To prevent static electricity your hand must touch the metal inlay on the underside of the vacuum handpiece. Be certain to continuously touch this inlay when...
^ A special parking attachment is fitted to all floor brushes. Insert the lower clip on the floor brush into the slot on the end of the vacuum cleaner from above. Turning on and off with the Park-System...
Page 22
Transport and storage Transport and storage ^ For easier transportation and storage stand the vacuum cleaner vertically. ^ Insert both clips of the floor brush into the two point holder on either side of the vacuum (this function cannot be used with the Powerbrush SEB 236).
Turn off and unplug the vacuum cleaner before performing any maintenance work. The Miele filter system consists of the following three components. – Dustbag – Exhaust filter – Dust compartment filter Each of these components must be changed periodically to maintain the vacuum cleaner’s efficiency.
When to change the dustbag Change the dustbag when the colored marker in the airflow indicator fills the display. Miele dustbags are disposable and made to be used only once. Do not attempt to reuse. Checking the airflow indicator ^ Attach the standard floor brush (depending on model) to the vacuum cleaner.
How to change the dustbag ^ Lift the release button for the dust compartment, raise the lid until it clicks into place. The dustbag has a closing flap which closes automatically when the dust compartment lid is raised to prevent any dust from escaping.
Maintenance and care When to change the Active HEPA exhaust filter Always change the Active HEPA filter when the filter change indicator (Reset button) lights. It is designed to light after approximately 50 hours of operation which is about a year of average use.
The filter change indicator (Reset button) must be reset each time the filter is replaced. To do this, the vacuum cleaner must be plugged in. ^ Press and hold the filter change indicator light until it goes out. The display is now reset.
Active HEPA filter. If an Air Clean filter is used, the reset button can be disregarded. The Air Clean filter should be changed whenever a new box of Miele dustbags is opened. The indicator goes out when the reset button is pressed.
Maintenance and care When to change the dust compartment filter Change the filter each time you open a new box of genuine Miele dustbags. A dust compartment filter is supplied with every box of Miele dustbags. How to change the exhaust filter ^ Open the dust compartment lid.
^ Push and take out the roller axle. ^ Take out the roller. ^ Remove all threads, hair, etc. and reassemble the parts. New thread catcher pads can be purchased from any authorized Miele vacuum dealer or Miele.
Turn off the vacuum and unplug it from the outlet before performing any maintenance work. Vacuum cleaner and accessories The vacuum cleaner and other plastic accessories can be cleaned with a damp cloth or a cleaner suitable for plastics. Do not use abrasive, glass or all purpose cleaners! They will damage the surface.
Frequently asked questions What if the vacuum turns off automatically. A warning light , comes on to indicate overheating. The vacuum has overheated. The temperature limiter automatically turns the vacuum off. This can occur if, for instance, large articles block the suction tube or when the filter bag is full or contains particles of fine dust.
Technical Service In the event of a fault which you cannot fix yourself please contact the Miele Service Department at the phone number listed on the back of this booklet. ^ Please quote the model type of your appliance. This can be found on the data plate on...
Optional accessories Some models come equipped with one or more of the following accessories. Turbobrush - Turbo Comfort-3 Observe the cleaning instructions of the floor manufacturer. The Turbobrush is recommended for cleaning short to medium pile carpeting. It is mechanically driven by the suction power of the vacuum.
Page 35
The parquet floor brush can be cleaned with the vacuum cleaner using the crevice nozzle if necessary. Floor brush - Parquet Twister with swiveling head For cleaning all hard flooring, e.g.
Page 36
Optional accessories Universal brush SUB 20 For dusting books, shelves, etc. For use with the supplied adapter. Mattress tool For cleaning deep crevices, mattresses and upholstery.
Page 37
Optional accessories Radiator brush (only usable with the crevice nozzle) For cleaning radiators, narrow shelves and crevices. Crevice nozzle 12" (300 mm) For cleaning in folds, crevices and corners.
Page 38
Optional accessories MicroSet This set is specially designed for cleaning small objects and difficult to reach areas (such as PC keyboards, stereo equipment, carved furniture, ornaments, models, etc). The set consists of: – Micro hose with combi nozzle (crevice nozzle and dust brush) –...
Disposal of packing materials The cardboard box and packing materials protect the appliance during shipping. Ensure that any plastic wrappings, bags, etc. are disposed of safely and kept out of the reach of children. These items pose a danger of suffocation. Caring for the environment Disposing of the dustbag and filters...
Page 40
All rights reserved / 2311 M.-Nr. 09 096 100 / 01 INFORMATION IS SUBJECT TO CHANGE. PLEASE REFER TO OUR WEBSITE TO OBTAIN THE MOST CURRENT PRODUCT SPECIFICATIONS, TECHNICAL & WARRANTY INFORMATION.