- GB These operating instructions apply to standard models S 360 - S 388 as well as to other S 300 series vacuum cleaners which are distinguished by names rather than numbers.
Contents Caring for the environment Description of the appliance Warning and Safety instructions Preparing for use Accessories supplied Using the accessories Floorhead ............13 Crevice nozzle .
Disposal of packing material The transport and protective packing has been selected from materials which are environmentally friendly for disposal and can normally be recycled. Ensure that any plastic, wrappings, bags etc. are disposed of safely and kept out of the reach of babies and young children.
Description of the appliance Some models are supplied with a Miele Electrobrush or Turbobrush as standard (not illustrated). These brushes are supplied with their own operating instructions.
Page 5
Floorhead u Carrying handle v Parking attachment The illustration shows the maximum number of features available on these Miele vacuum cleaners. Those features marked * depend on the model and may vary or not be available on your model.
Before using the vacuum cleaner, check for any signs of damage. Do not use a damaged appliance: it could be dangerous. The socket on the vacuum cleaner (depending on model) must only be used for the Miele Electrobrush specified for use with this appliance.
Page 7
If the cable is damaged it must be replaced together with a complete cable rewind. For safety reasons this must only be done by the Miele Service Department or a Miele authorised ser- vice technician. While the vacuum cleaner is under...
Page 8
Miele Spare Parts Department or via the internet on www.miele-shop.com. The Miele Electrobrush is a motor driven accessory for use only with Miele vacuum cleaners. The cleaner must not be used with an electrobrush produced by another manufacturer. To avoid the risk of injury when...
Attaching the suction hose ^ Insert the hose connector into the suction socket until it clicks into position. To remove the suction hose from the cleaner ^ Press the release buttons at the side of the hose connector and lift the hose from the socket.
Page 10
Preparing for use Connecting the suction tube sections (depending on model) Both sections of the suction tube have locating arrows marked on them. When connecting the two sections, ensure that the two arrows point towards each other. Adjusting the telescopic suction tube (depending on model) One part of the telescopic tube is...
Page 11
For hard flooring, such as stone and parquet, we recommend using one of the special Miele floor brushes (see "Optional accessories"). It is also important to observe the flooring manufacturer's cleaning and care instructions.
Accessories supplied Other tools, in addition to the floorhead(s), are supplied with the vacuum cleaner to help deal with various types of cleaning. - Crevice nozzle - Dusting brush - Upholstery nozzle These tools are stored in the special compartment in the vacuum cleaner and can be put back after use.
The different tools can either be fitted to the hand-piece or, as required, to the suction tube. Floorhead For general use and also for cleaning stairs. For safety reasons when vacuuming stairs it is best to start at the bottom of the stairs and move upwards.
Using the accessories Dusting brush For cleaning skirting boards, ornate or carved articles, etc. The head of the dusting brush can be swivelled to attain the best cleaning position. Upholstery nozzle For cleaning upholstery, mattresses, cushions, curtains, covers etc.
Unwinding and rewinding the mains cable Unwinding ^ Hold the plug and unwind cable to the required length (max. approx. 5.5 metres). Warning: If vacuuming for longer than 30 minutes, the mains cable must be pulled out to its fullest extent.
Operation Switching on and off ^ Press the On-Off switch. Vacuuming ^ When vacuuming pull the cleaner behind you on its wheels. You can stand it upright for vacuuming stairs and curtains etc. Warning: When vacuuming especially fine dust, e.g. sawdust, sand, plaster, flour, talcum powder etc., electrostatic charges build up naturally.
Regulating the suction (for models with a rotary suction power selector) The suction power can be regulated to suit the type of flooring. The higher the setting the more powerful the suction. Reducing the suction power reduces the amount of effort required to manoeuvre the floorhead.
^ Fit the floorhead into the parking attachment at the back the vacuum cleaner. Transportation and storage ^ Stand the vacuum cleaner upright when it is not being used and during storage. ^ Fit the floorhead into the parking attachment on the side of the vacuum cleaner.
^ Switch the vacuum cleaner on and turn the rotary selector (if applicable) to the highest power setting. ^ Lift the floorhead off the floor a little. If...
Switch off at the wall socket and remove the plug. If using the ACCU NOVA floorhead, switch this off as well. The Miele filter system consists of three filters which must be replaced from time to time to ensure that your cleaner performs efficiently.
Page 21
If you do not have one of these filters available you can use the SUPER air clean filter supplied with every packet of Miele dustbags instead. To use the SUPER air clean filter you will have to fit a filter frame*...
You can replace the exhaust filter supplied with the vacuum cleaner with one of the other Miele exhaust filters if you wish (see "Optional accessories"). N.B. If an ACTIVE air clean filter or an ACTIVE HEPA filter is used instead of...
To replace the dustbag and filters Open the dust compartment lid ^ Press the release button for the dust compartment lid and raise the lid as far as it will go. To replace the dustbag ^ To remove the dustbag hold the bag by the collar and pull it out of its holder.
Page 24
Maintenance and care Do not use more than one exhaust filter at a time. Replacing the SUPER air clean filter ^ Open the dust compartment lid. ^ Unclip the filter frame and raise it upwards. ^ Take hold of the used SUPER air clean filter by the clean, unsoiled section (see arrow) and take it out.
Take out the roller. Remove any threads and hair, replace the roller and refit the bearing. Replacement parts are available from your Miele dealer or from the Miele Spare Parts Department (see back cover for contact details). Maintenance and care...
E-Cloth A microfibre "E-Cloth" is available from Miele which is suitable for cleaning surfaces such as stainless steel, glass, plastic and chrome without the use of chemicals. It can be washed 300 times.
After sales service In the event of a fault that you cannot easily remedy, please contact – your Miele Dealer – the Miele Customer Contact Centre (see back cover for address). Please note that telephone calls may be monitored and recorded to...
Optional accessories Miele accessories including floorheads, filters and dustbags are available to order from your Dealer, the Miele Spare Parts Department or via the internet on www.miele-shop.com. Certain models are supplied as stan- dard with one or more of the following...
Page 29
The parquet floor brush can be cleaned with the vacuum cleaner using the crevice nozzle if necessary. ALLERGOTEC -3 floorhead The level of cleanliness of the floor shows in a colour "traffic light"...
Page 30
Optional accessories Dusting brush with natural bristles This brush is suitable for particularly delicate objects. Radiator brush For cleaning radiators, narrow shelves and crevices. ^ Attach the radiator brush to the crevice nozzle. Crevice nozzle (300 mm) For cleaning in folds, crevices or corners.
Page 31
Optional accessories Mattress nozzle For cleaning upholstery, mattresses, cushions, curtains, covers etc. Universal brush For dusting books, shelves, etc. MicroSet This set is specially designed for cleaning small objects and difficult to reach areas (such as PC keyboards, stereo equipment, intricately carved furniture and ornaments, models etc).
Page 32
Optional accessories CarClean Set Plus The CarClean Set Plus has been designed as an accessory for Miele cylinder vacuum cleaners for valeting the interior of cars. It consists of: – Hand-held Turbobrush – Micro-hose with combination nozzle (crevice nozzle and dusting brush) –...
Page 33
Optional accessories ACTIVE air clean filter The ACTIVE air clean filter is a special active charcoal filter which absorbs odours from the dust collected in the dustbag. It helps to prevent the build-up of odours. Do not use aroma capsules in your cleaner if you use this filter.
(BS 7671 in the UK). The voltage and connected load are given on the data plate located underneath the vacuum cleaner. Please ensure that these match the household mains supply. The fuse rating is quoted on the plug.
Page 36
Alteration rights reseved / (S 360 - S 388) - 1708 M.-Nr. 07 324 010 / 00...