Introduction
Important:
This document is intended for use by authorized service centers only.
"Service Schematics" was created with focus on customer care.
The purpose of this document is to provide further technical repair information for
NOKIA mobile phones on Level 3/4 service activities.
It contains additional information such as e.g. "Component finder",
"Frequency band table" or "Antenna switch table".
The "Signal overview" page gives a good and fast overview about the most
important signals and voltages on board.
Saving process time and improving the repair quality is the aim of this document.
It is to be used additionaly to the service manual and other training
or service information such as Service Bulletins.
All measurements were made using following equipment:
Nokia repair SW
:
Oscilloscope
:
Spectrum Analyzer
:
RF-Generator/GSM Tester :
Multimeter
:
While every endeavour has been made to ensure the accuracy of this document, some
errors may exist. If the reader finds any errors, NOKIA should be notified in writing.
Please send E-Mail to: training.sace@nokia.com
Customer Care / Service Operations / Content Creation Team
Confidential Copyright © 2007 NOKIA Only for training purposes
Service Schematics
Phoenix version 2006.44.6.163
Fluke PM 3380A/B
Advanced R3162 with an analog probe
Rhode & Schwarz CMU 200
Fluke 73 Series II
Version: 1.0 |
RM-176
15.02.2007
| 6290
| Board version: 1up_12 |
Table of contents
Frontpage
Copyright © NOKIA
This material , including documentation and any related computer programs is
protected by copyright, controlled by NOKIA. All rights are reserved. Copying,
including reproducing, modifying, storing, adapting or translating any or all of this
material requires the prior written consent of NOKIA. This material also contains con-
fidential information, which may not be disclosed to others whitout the prior written
consent of NOKIA.
Frontpage
1
2
3
4
5
6
7
8
9
10
11
|
Page 1(11)